Abstract:As one of the key components in scanning near-field optical microscopes (SNOM), optical fiber probes can be fabricated by use of either laser-heated pulling or chemical etching. For high-resolution near-field imagine, the nearfield optical signal is rapidly attenuated as the aperture of probes decreases. It is thus important to fabricate probes optimized for aperture size and optical transmission. We present a two step fabrication method of 50%similar to 70% reproducibility to obtain probes with high optical transmission efficiency as well as small tip diameters. First, optic fiber probes with the transitional taper in hyperbolic or parabolic shape are produced by use of the simple home-made device for heating-pulling. Then, a rapid chemical etching with 40% buffered hydrofluoric acid is used to sharpen the tip while keeping the taper shape and the conic angle unchanged. The method renders us to achieve probes with tip diameters in the range of 20nm similar to 200nm and the tape angle near the tip apex in the range of 20 degrees similar to 60 degrees. Particularly, the length of the non-propagating evanescent wave modes region decreases greatly to tens of micrometers or even less. In order to test the achieved probes, we give the photon tunneling decay curve and scanning near-field optical image of holographic grating by use of PSTM mode and collection-mode SNOM, respectively. In addition, an approach curve of shear force with hyperbolic probe is shown to verify its applicability to sample-tip distance regulation on basis of the principle of shear-force.

Fabrication of a Brush-Shaped Bent Fiber Probe for Near-Field Optics by Heated Pulling Combined with Chemical Etching

Fabrication And Characterization Of Near-Field Optical Fiber Nanoprobes With High Resolution And High Transmission Efficiency

Fabrication of high-quality fiber micro-probe for near-field optical microscope by laser-assisted melting and pulling method

Fabrication of Bend Optical Fibre Probes by Heated Pulling Combined with Chemical Ething

Development of optical fiber probe for the scanning near-field optical microscope

Fabrication and Application of Nearfield Optical Fibre Probe

A Method to Fabricate the Bifunctional Bent Optical Probes of AF/PSTM

Fabrication of Large Cone Angle Optical Fiber Probe by Dynamic Chemical Etching Method

Fabrication of High‐quality SNOM Probes by Pre‐treating the Fibres Before Chemical Etching

Fabrication and Characterization of Fiber-Optic Nano-Probes with High Transmission Efficiency and High Resolution

The Art of Electrochemical Etching for Preparing Tungsten Probes with Controllable Tip Profile and Characteristic Parameters

Analysis and preparation of optical fiber probe in scanning near-field optical microscope

Antenna-Attached Parabolic Probe for Excitation and Collection Modes in Snom

Design of Automatism Etching for Fabricating Fiber Probes of Scanning Near-field Optical Microscope

Electrochemical Preparation of STM Probes for High Aspect Ratio Nanometrology

A Method to Control the Fabrication of Etched Optical Fiber Probes with Nanometric Tips

Focusing Characteristics Optimization of Composite Near-Field Fiber Probe Based on Surface Plasmon

Fabrication of Fiber Probes Using Improved Turner Method

Optimization of Passive and Active Fiber Probe of Scanning Near-Field Optical Microscopy

Design and Optimization of Tapered Optical Fiber Probes for SERS Utilizing FDTD Method

SNOM Probe Based on Nano-Antenna with Large Aperture and High Resolution