Abstract:A mathematical model has been developed for prediction of the solidification front in the continuous strip casting process, through the fully coupled analysis of fluid flow and heat transfer of a solidifying shell. Fluid flow and heat transfer at the interface of the strip and mould were analysed with two- and three-dimensional (2D and 3D) finite volume methods. The numerical model considers a generalised set of mass, momentum and heat equations that is valid for the solid, liquid and solidification interval. A k–ϵ turbulence model, produced with the commercial program CFX, is used to analyse the solidification process of Cu–Cr alloy in the mould region of the caster. The heat flow and solidification processes have been studied experimentally. Cooling curves during solidification were registered using a thermocouple of type K connected to a data acquisition system. Temperature measurements were also performed in the mould and cooling water. The measured heat flux profiles were used as boundary conditions for the mathematical model. The fluid flow, temperature and heat flux distributions in the mould region of the caster were computed. The shape and location of the solidification front were also determined. Through the iterative analysis of the fluid flow, heat transfer and solidification behaviour, the heat transfer coefficient between the strand and the mould has been determined. The predicted temperature and heat flux distributions were compared with experimental measurements and reasonable agreement was obtained.

Numerical Prediction of Turbulent Flow and Heat Transfer with Phase Change in Crystallizer of Inverse Casting

Phase Field Simulation for Non-Isothermal Solidification of Multicomponent Alloys Coupled with Thermodynamics Database

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Mathematical modelling of fluid flow, heat transfer and solidification in a strip continuous casting process

Numerical Simulation of Solidification and Heat Transfer in Continuously Cast Bloom

Application of Phase-Field Method to Numerical Simulation of Solidification

Numerical Simulation on Fluid Flow, Heat and Mass Transfer in Solidification of Fe-C Alloys

Fluid Dynamic Numerical Simulation Coupled With Heat Transfer And Reaction In The Tubular Reactor Of Industrial Cracking Furnaces

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

Investigation of Solidification, Heat Transfer and Fluid Flow in Continuous Casting of Steel Using an Advanced Modeling Approach

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting

Numerical analysis of thermohydraulic behavior in a directional solidification furnace

A Three Dimensional Real-time Heat Transfer Model for Continuous Casting Blooms

Numerical Simulation of Molten Pool and Control Strategy of Kiss Point in a Twin-Roll Strip Casting Process

Numerical Simulation of Directional Solidification of Single Crystal Turbine Blade Casting

Modeling the effect of natural convection on macrosegregation of steel ingot by using a novel method

A mathematical model for predicting crystallization fouling in narrow rectangle channel incorporating crystal growth effect

Numerical Simulation of Multiphase Flow in Steel Continuous Casting Mold Using a Novel Euler–Euler–Lagrange Method