Abstract:In this study, we propose a theory of rough adhesive contact of viscoelastic materials in steady-state sliding. By exploiting a boundary formulation based on Green function approach, the unknown contact domain is calculated by enforcing the local energy balance at the contact edge, thus considering also the non-conservative work of internal stresses which is directly related to the odd part of the Green function. Theoretical predictions indicate that viscoelasticity may enhance the adhesive performance depending on the sliding velocity, thus leading to larger contact area and pull-off force compared to the equivalent adhesive elastic case The interplay between viscoelasticity and adhesion also affects the overall friction. Indeed, at low velocity, friction is strongly enhanced compared to the adhesiveless viscoelastic case, mainly due to the small-scale viscoelastic hysteresis induced by the adhesive neck close to the contact edge At higher velocity, the effect of viscoelastic hysteresis occurring at larger scales (bulk material) leads to even higher friction. Under these conditions, in the presence of adhesion, the small-scale and large-scale viscoelastic contributions to friction cannot be separated. Finally, in contrast with usual predictions for crack propagation/healing in infinite systems, we found a non-monotonic trend of the energy release rates at the trailing and leading contact edges, which is consistent with the finiteness of the contact length. All the presented results are strongly supported by existing experimental evidences.

Viscoelastic Adhesive Interfacial Model and Experimental Characterization for Interfacial Parameters

Viscoelastic Bilinear Cohesive Model and Parameter Identification for Failure Analysis of Adhesive Composite Joints

Identification of Time-Dependent Interfacial Mechanical Properties of Adhesive by Hybrid/inverse Method

Modeling the Interfacial De-Bonding Behavior Between Steel Wire and Adhesive

Mechanical Behaviors of Copolymer Elastomers: Experimental Characterization and Constitutive Modelling

Interfacial Modeling of Flexible Multilayer Structures

Finite Element Analysis of Adhesive Contact Behaviors in Elastoplastic and Viscoelastic Media

Investigation on Interfacial Bonding Strength of Anisotropic Conducive Adhesive with A New Cohesive Zone Model

A linear viscoelastic model for interfacial long-term behavior of FRP–concrete interface

Numerical Investigation on the Loading-Delamination-unloading Behavior of Adhesive Joints

Study on the Mechanical Behavior of Adhesive Interface by Digital Image Correlation

Visco‐elasto‐plastic constitutive model of adhesives under uniaxial compression in a range of strain rates

Analysis of Adhesive Contact of Heterogeneous Elastic Materials

Diffusive–stochastic–viscoelastic Model for Specific Adhesion of Viscoelastic Solids Via Molecular Bonds

Adhesive contact mechanics of viscoelastic materials

Trans-scale Characterization of the Thickness-Dependent Interfacial Strength of Adhesively Bonded Cylindrical Scarf Joints

A nonlinear viscoelastic–viscoplastic constitutive model for adhesives under creep

A New Model of Interfacial Adhesive Strength of Fiber-Reinforced Polymeric Composites Upon Consideration of Cohesive Force

Two Dimensional Analysis for an Adhesively Bonded Composite Single-Lap Joint Based on Flexible Interface Theory

Numerical Simulation of Viscous Adhesive Stress Tension Test and Viscous Adhesive Stress Model