Visco‐elasto‐plastic constitutive model of adhesives under uniaxial compression in a range of strain rates

Zhiyong Wang,Peifeng Li

DOI: https://doi.org/10.1002/app.48962

IF: 3

2020-01-17

Journal of Applied Polymer Science

Abstract:Mechanical behavior of a two‐component structural adhesive has been experimentally measured at the strain rates ranging from 0.001 to 2600 s−1. The elastic modulus, yield strength and flow stresses are all affected by the strain rate. A visco‐elasto‐plastic constitutive model is modified to reliably characterize the rate sensitive behavior of the adhesive.Determining the constitutive model of adhesives enables the prediction of the mechanical response of hybrid structures in which the adhesive is used. In this study, the stress–strain behavior of a two‐component structural adhesive was first measured in uniaxial compression experiments at the strain rates ranging from 0.001 to 2600 s−1 for developing a constitutive model. It was found that the compressive response, including elastic modulus, yield strength, and plastic flow stress, is substantially influenced by the strain rate. In plastic deformation, the strain rate sensitivity is not constant but varies with the rate; moreover, strain softening and hardening dominate the plastic deformation at low and high strains, respectively. A visco‐elasto‐plastic constitutive model was then proposed for the adhesive, integrating the strain rate sensitivity that was quantified by empirical equations. The model which was validated can reliably represent the strain rate dependent compressive behavior of the adhesive. © 2020 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020, 137, 48962.

polymer science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the viscoelastic - plastic constitutive behavior of two - component structural adhesives under uniaxial compression at different strain rates. Specifically, the research aims to determine the stress - strain response of the adhesive in a wide range of strain rates (from 0.001 to 2600 s\(^{-1}\)) through experimental measurement and modeling, including how mechanical properties such as elastic modulus, yield strength, and flow stress are affected by the strain rate. In addition, the research also focuses on the strain - softening and hardening phenomena in plastic deformation and proposes a viscoelastic - plastic constitutive model that can integrate these effects.

The key points of the paper include:
- **Experimental measurement**: Measure the mechanical response of the adhesive at different strain rates through uniaxial compression experiments.
- **Strain - rate sensitivity**: It is found that the elastic modulus and yield strength increase with the increase of the strain rate, and in plastic deformation, strain - softening is dominant at low strains and strain - hardening is dominant at high strains.
- **Model establishment**: A viscoelastic - plastic constitutive model is proposed, which combines strain - rate sensitivity and is verified by experimental data.

Through these studies, the author hopes to provide a reliable constitutive model for predicting the compressive behavior of adhesives at different strain rates, thereby providing theoretical support for design and application.