Abstract:Blank holder force (BHF) is one of the important process parameters in the deep drawing process. BHF helps produce defect-free components by controlling metal flow during the deep drawing process. If BHF is low, it causes wrinkling; otherwise, it causes the sheet to rupture. Therefore, optimization of BHF is an important issue in industries. One of the effective approaches to determining optimal BHF is to study forming force, thickness distribution, and wrinkles to produce a deep-drawn cup. The main function of this approach is that it minimizes the maximum forming force and prevents process limits. Therefore, this study aims to investigate the relationship between the BHF and forming force through experimental and simulation results. In addition, the effect of BHF on the thickness distribution and wrinkling is considered. Hence, numerical and experimental methods were employed for St14 and SS304L sheets with thicknesses of 0.5, 1, and 1.5 mm to achieve the objectives. Firstly, the simulation of the process was performed to study the mechanical behavior. Then, a set of experimental tests were conducted to validate the simulations. Finally, utilizing the experimental and numerical results, the optimal BHF value was determined. It was observed that the maximum thinning and maximum forming force are related to the forming process without BHF. Moreover, when the wrinkling at the edge of the part was removed by gradually increasing BHF, the minimum values of forming force and thinning were obtained. According to the investigations carried out on three thicknesses, it was observed that by reducing the thickness from 1.5 to 0.5 mm, the maximum forming force decreases in both SS304L and St14 sheets. However, the acquired results showed that the minimum optimal BHF is obtained in both sheets at a thickness of 1.5 mm. Overall, this research provides valuable experimental and numerical guidance for implementing the deep drawing process to manufacture cylindrical parts with minimum forming force required to save energy consumption.

Influences of Material Parameters on Deep Drawing of Thin-Walled Hemispheric Surface Part

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Research on the Critical Blank Holder Force of Elliptical Heads

Multi-scale numerical investigation of deep drawing of 6K21 aluminum alloy by crystal plasticity and a stress-invariant based anisotropic yield function under non-associated flow rule

Study on Deep drawing Forming Process of Wheel Disks

Improving parameters for achieving uniform cylindrical cup wall thickness in two-step deep drawing processes with SPCC sheet material

Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets

Effect of process parameters on the deep drawing formability of aluminum and advanced high-strength steel square cups

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

Optimization of Process Parameters in Deep Drawing Process Based on Orthogonal Experiment Method

Simulation and Microstructural Analysis of Twin-Induced Plasticity Steel Cylinder Deep Drawing

Anisotropic plasticity deformation during micro-deep drawing of 304 foils: An experimental and numerical investigation

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

Drawing with Thinning under Viscoplasticity Deformation of the Anisotropic Material

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

Finite Element Analysis of the Deep-drawing Stress of QT8812 Automobile Engine Oil Pan

Investigation on influences of initial residual stress on thin-walled part machining deformation based on a semi-analytical model