Abstract:The initial growing dendrite is influenced significantly by the complicated solidification conditions in continuously oscillating mold. The uneven growth of dendrite causes some defects seen commonly such as internal crack, subsurface porosity, subsurface inclusion and other defects of continuous casting billet. The induced initial defects in mold can be expanded and propagated in the following process such as secondary cooling, straightening, rolling and other subsequent handling procedure and then evolve into serious defects that can restrict the development and the quality refinement of final steel products. The mechanical stress caused by mold oscillation and the melt flowing is a crucial factor that leads to the uneven microstructure growth of initial solidifying shell in continuous casting mold. In this work, we simulate the growth and the morphology evolution of primary dendrites in mold area by using the cellular automaton (CA) method in combination with the actual conditions for continuously cast low carbon billet (Fe-0.6 wt.%C). Further, the mechanical state of initial dendrite is analyzed by regarding primary dendrite as a cantilever beam and its mechanical stress is calculated by combining thermo-physical properties and flow rate of steel based on the principle of materials mechanics to shed light on the formation of initial defects formation in mold area of continuous casting process. The results show that the solute concentration of initial dendrite tip gradually increases with undercooling from 2 to 10 K, and the maximum concentration rises by 0.07% when the increment of undercooling is 2 K. The length of dendrite arm increases significantly with undercooling from 2 to 6 K. However, the length of dendrite arm remains steady in a stable growth rate of 0.08 mms-1 when the undercooling is enhanced from 6 to 10 K. The increase of undercooling reduces the bending stress at dendrite root when the flow rate of molten steel is improved from 0.13 to 0.33 ms-1, while the mechanical stress continuously increases with the growth of primary dendrite at a constant undercooling. The bending stress of dendrite root has a high possibility to exceed its critical fracture strength under the condition of undercooling below 6 K or dendrite grow up more than 1 s. The primary dendrite is likely to be fractured and form initial defects of billet.

Modeling Study on Dendrite Growth of Steels During Slab Continuous Casting Process

A simple model on dendrite growth during steel continuous casting process

Modeling on Dendrite Growth During Slab Continuous Casting of Stainless Steels

Modeling on Dendrite Growth of Medium Carbon Steel During Continuous Casting

Simulation on the Microstructure and Microsegregation of Carbon Steel During Continuous Casting Process

Numerical Simulation of Dendritic Growth of Continuously Cast High Carbon Steel

Morphology Simulation and Mechanical Analysis of Primary Dendrites for Continuously Cast Low Carbon Steel

Modeling of Dendritic Evolution of Continuously Cast Steel Billet with Cellular Automaton

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Effect of traveling-wave magnetic field on dendrite growth of high-strength steel slab: Industrial trials and numerical simulation

Effect of casting speed on dendrite arm spacing of Mn13 steel continuous casting slab

Numerical Simulation of Dendrite Growth of Aluminum Alloy

Characteristic Parameters for Dendritic Microstructure of Solidification During Slab Continuous Casting

Comparative Study on the Initial Solidification Behavior of Continuous Casting Billets Between Low-Carbon Steel and Medium-Carbon Steel

Effect of microstructural parameters and casting conditions on the solidification microstructure of 430 stainless steel

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting

Heat transfer and solidification microstructure evolution of continuously cast steel by non-steady physical simulation

Numerical Simulation of Dendrite Growth in Ni-based Superalloy Casting During Directional Solidification Process

Numerical Modeling of Microstructure Evolution and Dendrite Growth for Al-Si Alloy Casting During Low Pressure Die Casting

Dendrite Growth Modelling of Cast Magnesium Alloy

Solidification morphology for full metallurgical length of continuous casting slab