Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

High Performance Three-Axis Actuator in Super-Multi Optical Pickup with Low Crosstalk Force

High-Sensitivity Actuator with New Magnetic Circuit in Optical Pickup

Integrated Optimization Design for High-Speed Three-Axis Actuator in Optical Pickup

Magnetic Circuit Design for Six-Wire Suspension Type Actuator in a Super Multioptical Pickup

Analysis of Movement Cross Interference in Optical Pickup Actuator for High Density and High Speed

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

Design of a Four-Sided Magnetic Circuit for an Optical Pickup Actuator for Multilayer High-Density Optical Disks

Study on the Movement Measurement for an Objective Lens Actuator in Optical Pickup

High-order resonance of three axis suspension wire actuator in optical pickup

Influence of Processing Factors on the Dynamic Characteristics of Optical Pickup Actuators

Push-pull large stroke flexure-based micropositioning stage driven by electromagnetic actuators with complementary double configuration

Improvement of high frequency dynamic performance of actuator in optical pickup by finite element and sensitivity methods

A Novel 4-Axis Magnetic Suspension Objective Lens Actuator

An asynchronous dual-foot inertial piezoelectric actuator with strong magnetic compatibility

Design and Experimental Investigation of Three Degrees of Freedom Nanoscale Microsuspension Actuators

Study on 3-DOF Kinetic Model of 2-D Actuator in Optical Pickup

Integrated Bi-Directional Focusing and Tracking Actuators in a Monolithic Device for a MEMS Optical Pick-Up Head

4-Axis Optical Head Lens Actuator for Disc Tilt Compensation

Optimized Dynamic Motion Performance for a 5-DoF Electromagnetic Manipulation

Development of Tracking and Focusing Micro Actuators for Dual-Stage Optical Pick-Up Head

Magnetostatic Torsional Actuator With Embedded Nickel Structures For The Improvement Of Driving Force And Wobble Motion