Abstract:A suitable reclosing time is important to guarantee the reliability of the power supply after a temporary failure in dc transmission lines. The design of the reclosing time mainly depends on the recovery time of the insulation strength. Here, an experimental platform was built that can simulate a real situation using a vertical extension arcing horn based on the post arc plasma dissipation. The entire macroperformance process, voltage and after-current characteristics were analyzed. The recovery times were measured under the conditions of the output current from 10 to 200 A and an initial gap length from 1 to 80 mm. The results show that the after-current can better represent the recovery time. The recovery time is a double-exponential function of the gap length and a power function of the initial current. The longest recovery time is 210 ms when the current is 200 A and the initial gap length is 1 mm, while the shortest recovery time is only 60 ms when the current is 10 A at an initial gap length of 40 mm. The entire process of the macroperformance contains three periods: the arc fuse burst, the transient arc extinction, and the post arc plasma dissipation. The maximum gap length for generating a continuous dc arc via the arc fuse is 0.4 mm when the terminal voltage is 560 V and the minimum current for this dc arc’s maintenance is 3.5 A under the condition of the maximum gap length. This article is aiming to provide some references for the reset of the reclosing times used in dc transmission grounding lines.

Energy Recovery Circuit with Auxiliary Power Supply for AC Plasma Display Panel

Efficiency Optimization of 40 Kw CAC-ZVS Three-phase PWM Rectifier

A Review of Energy Recovery Circuits for Plasma Display Panels

Design of a Scan Driver IC for Plasma Display Panel

High-voltage Integrated Circuit Technology for Plasma Display Panel Drivers

Design and analysis of an energy recycling electronic load system

Energy recycling load system with a high gain DC-DC converter for ultra low voltage power supplies

Research and Implementation Process of a 42" PDP Scan Driver IC"

Design ＆ Implementation of an Energy Saver IC for AC Contactor

Evaluation of Pulsed Power Sources for Plasma Generation

Zero-Voltage-Switching Single-Phase Inverter with Active Power Decoupling

Comparison of Two-Type Corona Plasma Energization Techniques: Ultra-Short and DC/AC Power Sources

AC/DC Power Modulation for Corona Plasma Generation

A Recovery Method for HVDC Systems Following AC System Faults

Study of Improving Luminous Efficacy of Plasma Display Panel in Sustain Period with Nanosecond Pulse Drive of Adjustable Waveform

A Current-Fed Resonant Plasma Source with Energy Compression Over Full Power Range

Study on the recovery circuit based on multi-module STRETCH meat grinder

A Simple Energy Recovery Circuit for High-Power Inverters with Complete Turn-on and Turn-off Snubbers

Zero-Voltage-Switching Single-Phase Full-Bridge Inverter With Active Power Decoupling

Recovery Time Representation Based on Post Arc Plasma Dissipation Using a Vertical Extension Arcing Horn

27.1: Invited Paper: High Efficiency Plasma Display Discharges