Abstract:Parallel operation of silicon carbide (SiC) metal oxide semiconductor field effect transistors MOSFET s is necessary for high power applications. However, the dynamic current sharing of paralleled devices is very sensitive to mismatched circuit parasitic inductances due to their high switching speeds Symmetric parasitic inductances are usually difficult to realize because of the limitation of circuit layout, especially when more than two devices are paralleled. In this paper, the effects of the circulating current in the drive circuit caused by the circuit mismatches, which result in dynamic current imbalance, are firstly analyzed in detail The influences of related drive circuit parameters are presented, which reveal the mechanism of namic current sharing Motivated by the analysis, a suppression method of the circulating current is proposed by inserting additional impedances in the drive circuit Considering the coupling noises introduced by the additional impedances, the concept of blocking unit is proposed to guarantee the proper operation of the drive circuit. A simple circuit implementation and the operation principle are presented. Finally, the drive method is validated by both simulations and experiments. Experimental results show the peak current imbalance is reduced from 16.5 % to 3.2% and the maximum switching loss imbalance is reduced by half.

Switching sensitive driver circuit to combat dynamic delay in on-chip buses

A New Current Switch Driver with Improved Dynamic Performance Used for 500ms/s, 12-Bit Nyquist Current-Steering DAC.

Fully Integrated High-Voltage Level Shifts and Drivers for Buck Converters.

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

A Novel Controlled Slew-Rate Output Driver

Crosstalk Immune Interconnect Driver Design

An Adjustable Gate Driver Based on the Optimization of Switching Transient Performances

An Active Gate Driver Design to Reduce Voltage and Current Overshoots for SiC MOSFET Modules

Design of Dual-Shared Dram Controller Based on Switch

Blocking EMI Optimization of the Drive Circuit for an Intelligent High Side Power Switch

Implementation of Low-Swing Differential Interface Circuits for High-Speed On-Chip Asynchronous Interconnection

Delay-Balanced Smart Repeaters for On-Chip Global Signaling

Low Swing Drivers Based on Charge Redistribution

Minimal-Power, Delay-Balanced Smart Repeaters for Global Interconnects in the Nanometer Regime

Analysis for Crosstalk of SiC-MOSFET in a Bridge Circuit and Its Active-Clamped Driver Based Suppression Methods

An Active Gate Driver for Dynamic Current Sharing of Paralleled SiC MOSFETs

Switching Noise Suppression for Hybrid Igbt Modules

Dynamic Current Balancing for Paralleled SiC MOSFETs with Circuit Mismatches Considering Circulating C Urrent in Drive Circuit

Energy Saving Method for On-Chip Data Bus Based on Bit Switching Activity Perception with Multi-encoding.

Efficient Transistor-Level QDI Asynchronous Switch for Neuromorphic Systems.

Monolithic GaN-Based Driver and GaN Switch With Diode-Emulated GaN Technique for 50-MHz Operation and Sub-0.2-ns Deadtime Control