Abstract:The emerging upward shield method (USM) for constructing vertical shafts has been used in various projects, including the Midosuji utility tunnel in Japan. A scaled-down model testing system, featuring a geometric similarity ratio of 1:30, was developed specifically for studying the USM. This system incorporates sand inflow control, propulsion control, data acquisition, and water level control. It facilitates detailed observation and recording of parameters such as vertical displacement of surface soil layers, support force at the excavation face, and earth pressure within the model box. Consequently, it enables investigation into the excavation face instability process, modes, and the formation and evolution of the soil arch zone above the excavation face during upward shield tunneling. Additionally, through the application of particle image velocimetry (PIV) technology and GeoPIV-RG software v1.1, quantitative analysis of soil displacement fields during excavation face instability is conducted, capturing microscopic displacements and deformations of soil planes. This approach more accurately elucidates the accuracy of understanding the dynamic response of soil. Pre-test research using the model testing system explores the variation patterns of excavation face load displacement, vertical earth pressure within the failure zone, surface displacement, and internal soil displacement during the instability process. Analysis reveals that excavation face load variation typically progresses through three stages: rapid growth, slow growth, and descent. Moreover, vertical earth pressure shifts upward in tandem with excavation face displacement, while overall surface displacement initially shows slight settlement followed by accelerated uplift.

The Reconfiguration Design of Redundant Thrust of Shields Excavating in Various Geologic Conditions

Analysis of reverse torque of EPB shield tunneling in soft ground

Grouping Strategy Research on Shield Machine Thrust System Excavating in Compound Geology

Compliance Characteristics of Propulsion System of Shield Tunneling Machine under Sudden Load

A New Calculation Model of Cutterhead Torque and Investigation of Its Influencing Factors

Modeling and Analysis of Thrust Force for Epb Shield Tunneling Machine

Study on Design Theory and Method of Geology Adaptability for Earth Pressure Balanced Shield Tunneling Machine

Nonlinear Cutterhead Pose Control of Large-Diameter Slurry Shields in Complicated Stratum

Dynamical Behavior of Redundant Thrusting Mechanical System in Shield Machines with Various Grouping Strategies

Torque Calculation Model of Cutting Head in Shield Machine and Experimental Study

Determination of the Cutterhead Torque for EPB Shield Tunneling Machine

Determination of Thrust Force for Shield Tunneling Machine

Design and Test of the Cutter-devices Hydraulic System of the Shield Tunneling Machine Based on System Recomposed Technology

Positioning Precision and Impact Force Control of Segment Erector for Shield Tunneling Machine

Mechanical structure and hydraulic system design of 1.2 m simulated shield machine

Design and Experiment of Hydraulic Propelling System in Shields

Total Thrust Calculation and Test Research for Soil Pressure Balancing Shield Tunneling

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling

A Redundantly Actuated PRPRP Radial Mechanism in the Segment Erector of a Shield Machine for Synchronization Control

Analysis for Dynamic Load Behavior of Shield Thrust System Considering Variable Boundary Constraints

Study on Collaborative Simulation of Excavation System of the Shield Machine in Composite Strata