Abstract:A micro flying slider is developed to satisfy the demands for large capacity, high data density, and fast transfer rate of mass storage systems. The air-bearing surface of the micro flying slider is designed based on micro fluid theory of hydrodynamics to obtain positive and negative pressures, thereby enhancing flying height stability. The lubrication model is investigated based on the generalized Reynolds equation. The finite volume method is utilized to solve the revised Reynolds equation that governs the air-bearing pressure and flying system behavior. The dynamic model for the slider–disk interface of the micro flying slider is developed, and the air-bearing system is modeled as a 3-degrees-of-freedom, lumped-parameter model to simulate flying characteristics. The air-bearing pressures with flying attitudes in the loading/unloading processes are characterized and calculated using the proposed model, with flying height and pitch angle as the key variables. The sample data obtained via accurate triggering and superposed averaging are processed to acquire modal frequencies and damping ratios based on the parameter identification method of modal analysis technique. System experiments are presented to illustrate the effectiveness of the proposed micro flying slider and its dynamic model for flying-height control. Theoretical analysis and experimental results show that a stable storage working process can be obtained at 1600 rpm and a pitch angle of 1.5°. Moreover, the micro flying slider exhibits satisfactory flying stability, with a near-field working distance of less than 75 nm. Good correlation between the experimental and simulation results is achieved.

Effects of environmental temperature and humidity on thermal flying height adjustment

Multiphysics-based Simulation on Heat Conduction Mechanism of TFC Head and Its Influencing Factors

Effects of Lubricant Viscosity-Temperature Relationship on the Capacity of Sliding Bearing

Wear Study For Dual-Heater Slider Under High Temperature

Effect of Low-Frequency Vibration in Z-Direction (Out-of-Plane) on Slider Dynamics

Experimental Study of Head-Disk Interface Flyability and Durability at Sub-1-nm Clearance

Investigation of Electrostatically Tunable Adhesion and Instability of Flying Head Slider

Flyability and Durability Test of Dynamic Fly-Height Sliders at 1-Nm Clearance

Analysis of Pressure Distribution on Head Disk Air Bearing Slider Involved Van Der Waals Force

Influence of Thermal Effect on Magnetic Head/Disk of Gas Thin Film Lubrication

Influence of Disk Surface Bulge and Hard Disk Operating Conditions on Hard Disk Gas Film Heat Transfer

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Dynamic Character of Ultra Thin Film Gas lubrication for Magnetic Head/Disk

Thermal Analysis on Active Heat Dissipation Design with Embedded Flow Channels for Flexible Electronic Devices

Surface Topology Optimization of Air Bearing Slider for Wear Durability in Magnetic Hard Disk Drives

Simulation of Dynamic Behavior of Slider at Head/Disk Interface of Hard Disk Drives

Head Flying Characteristics in Heat Assisted Magnetic Recording Considering Various Nanoscale Heat Transfer Models

Modeling, Design and Analysis of a Micro Flying Slider in Near-Field Optical Storage System

Research on the Design and Fabrication of Air Bearing Sliders in Hard Disk Drives

Numerical Analysis about the Influence of Thermal Deformation of Magnetic Head on Fly Height

Simulation of Load/unload Process and Parameter Optimization for a Hard Disk Drive