Abstract:Rotating stall is one of the most important sources of performance deterioration and system instability in axial flow compressors and, therefore, it is of great value for compressor aerodynamic design and the development of active control strategies. It has been widely demonstrated that peculiar flow mechanisms, such as tip clearance leakage vortices, play a decisive role in the genesis of rotating instabilities (RI) and stall inception, however it is still very hard to predict and interpret such mechanisms accurately. This paper presents the results of both experimental and numerical researches dealing with forming process of rotating stall in a 1.5-stage low-speed industrial axial compressor at Harbin Engineering University. A new physical mechanism for explaining the birth of rotating instabilities based on the detection of spike waves is introduced as a result of a deep analysis recognising the role due to low-energy flow migration of along the rotor spanwise direction. To this purpose, transient pressure signals obtained from both experiments and simulations were adopted to describe flow details during onset and scanning pressure contours on the compressor casing were obtained both experimentally and numerically during the process of approaching stall point so that the transition process from RI to the appearance of spike waves could be well captured. The experimental results showed that the frequencies of RI dropped nearly linearly against the flow coefficient and the strength of radial secondary flows increased distinctly, which induces the boundary layer separation near leading edge in the tip region at last. Full-annulus URANS numerical simulations using SST turbulence model were performed and validated adequately by test data, and then employed to capture more flow details and support better understanding of the flow physics. In fact, a lateral tornado-type vortex occurring before the trailing edge backflow and featuring the same frequency of early pressure disturbances was observed numerically. Under the combined effect of the lateral tornado-type vortex and the tip secondary vortex, a trailing edge reverse flow was observed which produced a huge increase of blockage. A radial tornado vortex was formed connecting the suction side and casing wall at the same time finally leading to the spike-wave rotating stall.

Rotating Stall Control Via Bifurcation Stabilization

Bifurcation Suppression of Nonlinear Systems Via Dynamic Output Feedback and Its Applications to Rotating Stall Control

Nonlinear Instability of Axial Flow Compression Systems

Rotating Stall Control for Axial Compression System with Close Coupled Valves

Nonlinear Feedback Control for Rotating Stall and Surge of an Axial Flow Compressor

Computational Model for Stall Inception and Nonlinear Evolution in Axial Flow Compressors

Identification and rapid detection of rotating stall via deterministic learning

Local robustness of stationary bifurcation control

Dynamic surface control design for the rotating stall and surge in an aeroengine compressor

The role of radial secondary flow in the process of rotating stall for a 1.5-stage axial compressor

Research on Stall Mechanism Based on Vorticity Dynamics in a Single-Rotor Axial Compressor

An Investigation on Rotating Stall in an Aeroengine Transonic Compressor with Inlet Distortion

A High-Order Model of Rotating Stall in Axial Compressors with Inlet Distortion

Analysis on the Spike-type Rotating Stall for Axial Compressor by Dynamic Mode Decomposition

Analysis on Spike-Type Rotating Stall in Transonic Axial Compressor by Dynamic Mode Decomposition

Bifurcation Predication in Axial Compressors with Nonuniform Inflow Via Deterministic Learning

A new model for compressor surge and stall control

The Investigation of Axial Compressor With Aggressive Flow Path Near Stall Condition

Aerodynamic Instabilities of Swept Airfoil Design in Transonic Axial-Flow Compressors

Investigation on Mode Characteristics of Rotating Instability and Rotating Stall in an Axial Compressor

Numerical bifurcation analysis of static stall of airfoil and dynamic stall under unsteady perturbation