Abstract:The problem of controlling surge and stall in jet engine compressors is of fundamental importance in preventing damage and lengthening the life of these components. In this paper, we use the Moore-Greitzer mathematical model to develop an output feedback controller for these two instabilities (only one of the three states is measurable). This problem is particularly challenging since the system is not completely observable and, hence, none of the output feedback control techniques found in the literature can be applied to recover the performance of a full state feedback controller. However, we show how to successfully solve it by using a novel output feedback approach for the stabilization of general stabilizable and incompletely observable systems.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to control two unstable phenomena in jet - engine compressors: rotating stall and surge. These problems are crucial for preventing damage and prolonging the service life of these components. Specifically, the paper uses the Moore - Greitzer mathematical model to develop an output - feedback controller to stabilize these two instabilities. Since the system is not fully observable, traditional output - feedback control techniques cannot be directly applied. The paper proposes a novel output - feedback method for stabilizing generally stabilizable and partially observable systems. ### Specific description of the problem 1. **Rotating stall**: When there are stagnant flow areas around the compressor, it will lead to blade vibration and a reduction in compressor boost pressure. 2. **Surge**: This is an axisymmetric oscillation through the compressor, which may lead to the vibration of other compression - system components and engine damage. ### Model and challenges - Use the Moore - Greitzer three - state model (MG3) to describe the compression system. - The state variables of the system include mass flow rate \(\Phi\), total - duct pressure rise \(\Psi\) and the normalized squared amplitude of the stall cell \(R\). - Since the system becomes unobservable when there is no mass flow through the compressor, traditional output - feedback control methods are not applicable. ### Solution The paper proposes a new globally stable full - state - feedback control law and utilizes the output - feedback control theory for non - fully - observable nonlinear systems to regulate stall and surge using only pressure measurement data. Specifically: 1. **State - feedback controller design**: - A new control law \(\bar{u}=(1 - \beta^{2}k_{1}k_{2})\phi+\beta^{2}k_{2}\psi + 3\beta^{2}k_{1}R\phi\) is proposed, where \(k_{1}\) and \(k_{2}\) are positive scalars that satisfy specific inequalities. 2. **Output - feedback controller design**: - An observer is designed to estimate the unmeasurable state variables. - The projection method is used to ensure that the observer estimates are within the observable space. ### Conclusion Through the above methods, the paper successfully solves the control problems of stall and surge in jet - engine compressors and can achieve global stability even when the system is not fully observable. This provides important theoretical and technical support for practical engineering applications.

Output Feedback Control of Jet Engine Stall and Surge Using Pressure Measurements

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Robust H∞ Output Feedback Control for Markovian Jump Systems with Actuator Saturation

Output Feedback Stabilization of Uncertain Time‐Delay Systems Containing Saturating Actuators

Surge Process of a High-Speed Axial–Centrifugal Compressor

Nonlinear Feedback Control for Rotating Stall and Surge of an Axial Flow Compressor

Compressor Stability at Pulsating Condition Via Gas Dynamics Responses Analysis

A new model for compressor surge and stall control

Unsteady Flow and Aeroelasticity Behavior of Aeroengine Core Compressors During Rotating Stall and Surge

A Characteristic-Based 1D Axial Compressor Model for Stall and Surge Simulations

Nonlinear Instability of Axial Flow Compression Systems

Dynamic surface control design for the rotating stall and surge in an aeroengine compressor

Surge and stall instabilities finite-time control of nonlinear uncertain-disturbed compression system by using a novel robust approach

Rotating Stall Control Via Bifurcation Stabilization

Basic Dynamical Systems Control of Aeroengine Flow

Surge-elimination Strategy for Aero-engine Transient Control

Numerical Study of Fuel Spiking Induced Surge in a Small-scale Aircraft Engine

Machine learning for optimal flow control in an axial compressor

A novel aeroengine real-time model for active stability control: compressor instabilities integration

A Bayesian Optimization Framework for the Control of Combustion Instability of a Bluff-Body Stabilized Combustor

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile