Abstract:The influencing characteristic for the evolution mechanism of a dynamic stall vortex structure and distributed blowing control on rotor airfoils was investigated. Based on the moving-embedded grid method, the finite volume scheme, and Roe's FDS scheme, a simulation method for the unsteady flow field of a pitch-oscillating airfoil was established. The flow field of the NACA63-218 airfoil was calculated using Reynolds-averaged Navier–Stokes equations. The evolution processes of different vortex structures during dynamic stall and the principal controlled vortex mechanism affecting aerodynamic nonlinearity were analyzed based on the pressure contours Cp and Q of the flow field structure and the spatiotemporal evolution characteristics of the wall pressure distribution. The research indicated that dynamic stall vortices (DSVs) and shear layer vortices (SLVs) were the major sources of the increase in aerodynamic coefficients and the onset of nonlinear hysteresis. Building upon these findings, the concept of distributed blowing control for DSVs and shear layer vortices (SLVs) was introduced. A comparative analysis was conducted to assess the control effectiveness of dynamic stall with different blowing locations and blowing coefficients. The results indicated that distributed blowing control effectively inhibited the formation of DSVs and reduced the intensity of SLVs. This led to a significant decrease in the peak values of the drag and pitch moment coefficients and the disappearance of secondary peaks in the aerodynamic coefficients. Furthermore, an optimal blowing coefficient existed. When the suction coefficient Cμ exceeded 0.03, the effectiveness of the blowing control no longer showed a significant improvement. Finally, with a specific focus on the crucial motion parameters in dynamic stall, the characteristics of dynamic stall controlled by air blowing were investigated. The results showed that distributed air blowing control significantly reduced the peak pitching moment coefficient and drag coefficient. The peak pitching moment coefficient was reduced by 72%, the peak drag coefficient was reduced by 70%, and the lift coefficient hysteresis loop area decreased by 46%. Distributed blowing jet control effectively suppressed the dynamic stall characteristics of the airfoil, making the unsteady load changes gentler.

Dynamic surface control design for the rotating stall and surge in an aeroengine compressor

Nonlinear Feedback Control for Rotating Stall and Surge of an Axial Flow Compressor

The Nonlinear Single Controller Of Dgen380 Aero Engine Design

An Integrated Controller Design for a Small Aero-Engine

Dynamic Surface Control of Constrained Hypersonic Flight Models with Parameter Estimation and Actuator Compensation

Design of Thrust Vectoring Vertical/Short Takeoff and Landing Aircraft Stability Augmentation Controller Based on L1 Adaptive Control Law

Dynamic Surface Control Designing and Simulation for Hypersonic Vehicle

Observer-based Dynamic Surface Control for High-Performance Aircraft Subjected to Unsteady Aerodynamics and Actuator Saturation.

Neural Predictor-Based Dynamic Surface Predictive Control for Power Converters

Adaptive Continuous Neural Pitch Angle Control for Variable‐Speed Wind Turbines

Rotating Stall Control Via Bifurcation Stabilization

Deep reinforcement learning based active surge control for aeroengine compressors

Dynamic surface tracking controller design for a constrained hypersonic vehicle based on disturbance observer

Nonlinear Design Method for Improving Aero-Engine Control Performance

Surge-elimination Strategy for Aero-engine Transient Control

Dynamic Surface Control of Hypersonic Aircraft with Parameter Estimation

Unified Control of Flight Dynamics and Actuators Using Local Accelerations

Surge and stall instabilities finite-time control of nonlinear uncertain-disturbed compression system by using a novel robust approach

Nonlinear Control of Turbofan Engines: an Active Set-Based Method for Performance Optimization

Bifurcation Suppression of Nonlinear Systems Via Dynamic Output Feedback and Its Applications to Rotating Stall Control

Numerical Investigation on the Evolution Process of Different Vortex Structures and Distributed Blowing Control for Dynamic Stall Suppression of Rotor Airfoils