Abstract:The Centrifugal compressor is a piece of key equipment for petrochemical factories. As the core component of a compressor, the blades suffer periodic vibration and flow induced excitation mechanism, which will lead to the occurrence of crack defect. Moreover, the induced blade defect usually has a serious impact on the normal operation of compressors and the safety of operators. Therefore, an effective blade crack identification method is particularly important for the reliable operation of compressors. Conventional non-destructive testing and evaluation (NDT&E) methods can detect the blade defect effectively, however, the compressors should shut down during the testing process which is time-consuming and costly. In addition, it can be known these methods are not suitable for the long-term on-line condition monitoring and cannot identify the blade defect in time. Therefore, the effective on-line condition monitoring and weak defect identification method should be further studied and proposed. Considering the blade vibration information is difficult to measure directly, pressure sensors mounted on the casing are used to sample airflow pressure pulsation signal on-line near the rotating impeller for the purpose of monitoring the blade condition indirectly in this paper. A big problem is that the blade abnormal vibration amplitude induced by the crack is always small and this feature information will be much weaker in the pressure signal. Therefore, it is usually difficult to identify blade defect characteristic frequency embedded in pressure pulsation signal by general signal processing methods due to the weakness of the feature information and the interference of strong noise. In this paper, continuous wavelet transform (CWT) is used to pre-process the sampled signal first. Then, the method of bistable stochastic resonance (SR) based on Woods-Saxon and Gaussian (WSG) potential is applied to enhance the weak characteristic frequency contained in the pressure pulsation signal. Genetic algorithm (GA) is used to obtain optimal parameters for this SR system to improve its feature enhancement performance. The analysis result of experimental signal shows the validity of the proposed method for the enhancement and identification of weak defect characteristic. In the end, strain test is carried out to further verify the accuracy and reliability of the analysis result obtained by pressure pulsation signal.

Gas turbine blade fracturing fault diagnosis based on broadband casing vibration

Research on the Influence of Crack Parameters on the Vibration Characteristics of Gas Turbine Compressor Blades

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

Research on Wind Turbine Fault Diagnosis Technology Based on Big Data

Research On Wind Turbine Blade Surface Damage Fault On-Line Monitoring And Diagnosis System

Research on Model-Based Fault Diagnosis for a Gas Turbine Based on Transient Performance

Review on the Damage and Fault Diagnosis of Wind Turbine Blades in the Germination Stage

Research on a Method for Online Damage Evaluation of Turbine Blades in a Gas Turbine Based on Operating Conditions

Wind Turbine Blade Bearing Fault Diagnosis Under Fluctuating Speed Operations via Bayesian Augmented Lagrangian Analysis

Condition monitoring of wind turbine blades via learning-based methods

Fault Diagnosis of Industrial Wind Turbine Blade Bearing Using Acoustic Emission Analysis

Weak Defect Identification for Centrifugal Compressor Blade Crack Based on Pressure Sensors and Genetic Algorithm

Nonlinear vibration characteristics and damage detection method of blade with breathing fatigue crack

Gas turbine failure classification using acoustic emissions with wavelet analysis and deep learning

Acoustic Emission Analysis for Wind Turbine Blade Bearing Fault Detection Under Time-Varying Low-Speed and Heavy Blade Load Conditions

A novel graph structure data-driven crack damage identification for compressor blade based on vibro-acoustic signal

In Situ Detection of Turbine Blade Vibration and Prevention

An Effective Fault Feature Extraction Method for Gas Turbine Generator System Diagnosis

Early warning of damaged wind turbine blades using spatial–temporal spectral analysis of acoustic emission signals

A time-series turbofan engine successive fault diagnosis under both steady-state and dynamic conditions