Abstract:An air-separation unit (ASU) uses atmospheric air to produce essential pure gaseous and liquid products for many industrial sectors but requires intensive power consumption. In recent years, cryogenic liquid turbine expanders have been used to replace the traditional J-T valves in air-separation units to save energy. In this paper, an effective design optimization method is proposed to suppress swirling flow and mitigate cavitation in liquid turbines. A flexible tuning of the impeller and fairing cone geometries is simultaneously realized, where the optimization variables are identified via a geometric sensitivity study. A novel objective function is deliberately established by allowing both swirling flow and cavitation characteristics, driving the optimizer to search for deswirling and cavitation-resistant geometries. A kriging surrogate model with an adaptive sampling strategy and a cooperative co-evolution algorithm (CCEA) are incorporated to solve the highly nonlinear optimization problem, where the former reduced the costly evaluations but simultaneously maintained the model prediction accuracy and enabled the aim-oriented global searching (the latter decomposes the problem into several readily solved sub-problems that could be solved in parallel at a high-convergence rate). The optimized impeller and fairing cone geometries were quite favorable for suppressing swirling flow and mitigating cavitation. The impeller cavitation was significantly reduced, with the maximal vapor volume fraction reduced from 0.365 to 0.17 at the blade surface; the diffuser tube high-swirl flow was significantly deswirled and the intensive vapor fraction around the centerline largely reduced, with the maximal vapor volume fraction in the diffuser tube reduced from 0.387 to 0.121. As a result, the isentropic efficiency of the liquid turbine expander was improved from 88.4% to 91.43%.

Optimization of exhaust ejector system for marine gas turbine enclosure cooling: Computational fluid dynamics analysis and parameter optimization

Optimization of Dual-Impeller Configurations in a Gas–Liquid Stirred Tank Based on Computational Fluid Dynamics and Multiobjective Evolutionary Algorithm

A New and Better Optimization of Supersonic Ejector Design

Coupled Aerothermodynamics Optimization for the Cooling System of a Turbine Vane

Fluid-Thermal-Structural Analysis of Partial Admission Axial Impulse Turbines with Liquid Jet Impingement Cooling

Cavitation Suppression and Design Optimization in a Cryogenic Liquid Turbine Expander Based on Thermodynamic Cavitation and Entropy Production Analysis

Parameter Optimization of Combustor Dump Diffuser Based on RSM

Multidisciplinary Design and Multi-Objective Optimization on Guide Fins of Twin-Web Disk Using Kriging Surrogate Model

Simulation Analysis of Ejector Optimization for High Mass Entrainment under the Influence of Multiple Structural Parameters

Cryogenic Cavitation Mitigation in a Liquid Turbine Expander of an Air-Separation Unit through Collaborative Fine-Tuned Optimization of Impeller and Fairing Cone Geometries

Aerodynamic modification and optimization of intermediate pressure compressor in marine intercooled recuperated gas turbine

Numerical optimization on the geometrical factors of natural gas ejectors

Shape optimization and flow irreversibility mechanism analysis of normal temperature, high temperature and wet stream ejectors

Optimal Design of Steam Ejector by Computational Fluid Dynamics Simulation

Aerodynamic Optimization System Development For Low Pressure Exhaust Hood Of Steam Turbine

Performance Improvement of Two-Phase Steam Ejector based on CFD Techniques, Response Surface Methodology and Genetic Algorithm

Numerical investigation on performance optimization of steam ejector considering full geometric parameters and working conditions

Multi-Objective Aerodynamic Optimization of Gas Turbine Exhaust Diffuser: Experimental and Numerical Validations

Optimization of cooling structures in gas turbines: A review

Optimization of Geometric Parameters of Ejector for Fuel Cell System Based on Multi-Objective Optimization Method

Optimization of the Blade Profile and Cooling Structure in A Gas Turbine Stage Considering Both the Aerodynamics and Heat Transfer