Abstract:In this paper, an equivalent welding model is proposed that takes the tensile stress and strain parameters of the axial weld area of the roll-welded bellows as the material properties to replace welding simulation. The integrated finite element method is used to simulate the following two model forming processes for the roll-welded bellows: (i) welding-bulging-repeated bending model, and (ii) equivalent welding-bulging-repeated bending model. The stress and strain distributions of the two models are compared and analyzed, and the main failure areas of the roll-welded bellows in the repeated bending process are predicted. At the same time, the accuracy of the model prediction is verified by the limited repeated bending test of the roll-welded bellows, and the failure mechanism of the roll-welded bellows is revealed. The results indicate that the stress and strain distributions of the two models are essentially the same, thus verifying the feasibility of the equivalent welding model. When the cyclic deformation reaches the limit, the predicted stress failure risk zone is located at the base metal position of the first wave-like trough of the bellows near the heat affected zone at the fixed end, which is consistent with the experimental results. This indicates that the equivalent welding-bulging-repeated bending model can accurately predict the position of the repeated bending fatigue failure of the bellows, thus laying a foundation for the optimization of the roll-welded bellows.

Improved SWT model for predicting multiaxial fatigue life of bellows under combined movement load

Improved Ultra-Low Cycle Fatigue Fracture Models for Structural Steels Considering the Dependence of Cyclic Damage Degradation Parameters on Stress Triaxiality

Multiaxial high-cycle fatigue failure and life prediction based on critical plane method

Fatigue Life and Experimental Study of High-Temperature Bellows Based on the Improved Manson-Coffin Equation

Prediction of long-term fatigue life of CFRP composite hydrogen storage vessel based on micromechanics of failure

A New Model of Multiaxial Fatigue Life Prediction with the Influence of Different Mean Stresses

Finite element simulation prediction of repeated bending failure zone of roll-welded bellows based on an equivalent welding model

An improved critical plane-energy multiaxial fatigue life prediction model considering shear mean stress

Fatigue Life Prediction of Notched Details Using SWT Model and LEFM-Based Approach

A Novel Energy-Critical Multiaxial Fatigue Life Prediction for Low Cycle Fatigue under Mixed-Mode Loading

Fatigue Life Prediction of Rolling Bearings Based on Modified SWT Mean Stress Correction

A modified SWT model for very high cycle fatigue life prediction of L-PBF Ti-6Al-4 V alloy based on Single Defect: Effect of building orientation

A New Critical Plane-Energy Model for Multiaxial Fatigue Life Prediction of Turbine Disc Alloys

Determining the Walker exponent and developing a modified Smith-Watson-Topper parameter model

Critical Plane–based Multiaxial Fatigue Life Prediction of Turbine Disk Alloys by Refining Normal Stress Sensitivity

A New Energy-Critical Plane Damage Parameter for Multiaxial Fatigue Life Prediction of Turbine Blades

A modified method of von Mises stress-based MWCM for fatigue-life prediction under fully-reversed axial-torsion proportional loads

A life prediction model for rolling contact fatigue based on the improved moment of load path method

Mixed-mode Fatigue Crack Growth Prediction in Biaxially Stretched Sheets

Multiaxial Low Cycle Fatigue Assessment of Notch Specimens for 10crni3mov Steel and Its Welds

Strain Energy-Based Multiaxial Fatigue Life Prediction under Normal/shear Stress Interaction