Abstract:Organic photovoltaics (OPVs) have been considered as one of the preliminary candidates for the third-generation solar cells due to their particularly advantages, such as light-weight, low cost, solution processability and mechanical flexibility. In recent years, the power conversion efficiency (PCE) of OPVs has achieved remarkable progress with the development of non-fullerene acceptors (NFAs), which exhibit stronger capability of light absorption and stability than the fullerene acceptors. However, the narrow absorption properties of organic materials still restrict the further breakthrough of the performance of OPVs. It is difficult for the binary heterojunction films to realize the effective wide spectrum utilization of solar energy. Ternary strategy, which consists of one donor and two acceptors or two donors and one acceptor in a bulk-heterojunction, has proven to be an effective and facile way to enhance performances of OPVs. The emergence of new NFAs such as ITIC, IT-4F, Y6 etc. greatly increases the selectivity of acceptors in a ternary system. It is necessary to investigate the compatibility of latest NFA materials and corresponding ternary device performance. In this article, we report a new ternary OPV system with dual NFAs and a polymer donor. The excellent NFA material (Y6), which was first reported in 2019, is used as the third component. Different concentrations of Y6 are introduced into the binary system based on PBDB-T-2F:IT-4F. The compatibility between materials and device performances are investigated through absorption capability of blend films, AFM, water contact angle, GISAXS, and corresponding electrical properties of devices. The 12.48% PCE is achieved from ternary OPVs with PBDB-T:IT-4F as the active layers containing 20wt% Y6 in acceptors, resulting from the enhanced Jsc of 22.09 mA/cm2, Voc of 0.83 V and FF of 68.45%. The origin of the improvement of the ternary OPVs is summarized below. Firstly, an apparently complementary absorption spectrum is obtained through the introduction of Y6, which has a stronger photo harvesting capability in the spectral range from 750 to 950 nm than IT-4F, and higher short current density (Jsc) is observed in the ternary devices than in the binary device. Secondly, a rougher surface of the active layer is observed by increasing the Y6 concentration, which may result in an inferior exciton dissociation and charge transport process, the existence of larger-scaled crystal is proved by the GISAXS technology. Thirdly, the introduced Y6 can help to suppress the bimolecular recombination, which is in favor of the incremental device performance. Approximately 17.85% PCE improvement is obtained in comparison with PBDB-T-2F:IT-4F based binary OPVs.

High Conduction Band Polymer Acceptor as a Ternary Component for Indoor Power Generation and Photodiode: Enhanced Photovoltage and Suppressed Dark Current

Hybrid Nonfused Electron Acceptors with Perylene Diimide Pendants for Organic Solar Cells

Dual Non-Fullerene Acceptors Based High Efficiency Ternary Organic Solar Cells

A Simple-Structure Small-Molecule Acceptor Enables over 18% Efficiency Ternary Polymer Solar Cells with a Broad Composition Tolerance

High-Performance Ternary Organic Photovoltaics Incorporating Small-Molecule Acceptors with an Unfused-Ring Core

Dithienopyrrolothiophene (DTPT) Based Acceptors for Fine-Tuning Molecular Packing and Enhancing Ternary Organic Photovoltaic Performance

Asymmetric Indenothiophene-Based Nonfullerene Acceptors for Binary- and Ternary-Blend Polymer Solar Cells

18% Efficiency of Ternary Organic Solar Cells Enabled by Integrating a Fused Perylene Diimide Guest Acceptor

Enhanced Electron Transport and Heat Transfer Boost Light Stability of Ternary Organic Photovoltaic Cells Incorporating Non‐Fullerene Small Molecule and Polymer Acceptors

Boosting the efficiency of organic solar cells via dual non-fullerene acceptors

High‐Performance Ternary Organic Solar Cells Enabled by Integrating a 3d‐shaped Guest Acceptor Derived from Perylene Diimide

Approaching 18% efficiency of ternary organic photovoltaics with wide bandgap polymer donor and well compatible Y6 : Y6-1O as acceptor

Two compatible non-fullerene acceptors towards efficient ternary organic photovoltaics

Enhanced Fill Factor and Efficiency of Ternary Organic Solar Cells by a New Asymmetric Non‐Fullerene Small Molecule Acceptor

16.7%-efficiency ternary blended organic photovoltaic cells with PCBM as the acceptor additive to increase the open-circuit voltage and phase purity

Ternary Organic Blend Approaches for High Photovoltaic Performance in Versatile Applications

A Near-Infrared Photoactive Morphology Modifier Leads to Significant Current Improvement and Energy Loss Mitigation for Ternary Organic Solar Cells

The Multi-Functional Third Acceptor Realizes the Synergistic Improvement in Photovoltaic Parameters and the High-Ratio Tolerance of Ternary Organic Photovoltaics

Mechanistic Investigation into Dynamic Function of Third Component Incorporated in Ternary Near‐Infrared Nonfullerene Organic Solar Cells

High-performance ternary solar cells by introducing a medium bandgap acceptor with complementary absorption, reducing energy disorder and enhancing glass transition temperature

Efficient All‐Polymer Solar Cells Enabled by a Novel Medium Bandgap Guest Acceptor