Abstract:Organic photovoltaics (OPVs) have been considered as one of the preliminary candidates for the third-generation solar cells due to their particularly advantages, such as light-weight, low cost, solution processability and mechanical flexibility. In recent years, the power conversion efficiency (PCE) of OPVs has achieved remarkable progress with the development of non-fullerene acceptors (NFAs), which exhibit stronger capability of light absorption and stability than the fullerene acceptors. However, the narrow absorption properties of organic materials still restrict the further breakthrough of the performance of OPVs. It is difficult for the binary heterojunction films to realize the effective wide spectrum utilization of solar energy. Ternary strategy, which consists of one donor and two acceptors or two donors and one acceptor in a bulk-heterojunction, has proven to be an effective and facile way to enhance performances of OPVs. The emergence of new NFAs such as ITIC, IT-4F, Y6 etc. greatly increases the selectivity of acceptors in a ternary system. It is necessary to investigate the compatibility of latest NFA materials and corresponding ternary device performance. In this article, we report a new ternary OPV system with dual NFAs and a polymer donor. The excellent NFA material (Y6), which was first reported in 2019, is used as the third component. Different concentrations of Y6 are introduced into the binary system based on PBDB-T-2F:IT-4F. The compatibility between materials and device performances are investigated through absorption capability of blend films, AFM, water contact angle, GISAXS, and corresponding electrical properties of devices. The 12.48% PCE is achieved from ternary OPVs with PBDB-T:IT-4F as the active layers containing 20wt% Y6 in acceptors, resulting from the enhanced Jsc of 22.09 mA/cm2, Voc of 0.83 V and FF of 68.45%. The origin of the improvement of the ternary OPVs is summarized below. Firstly, an apparently complementary absorption spectrum is obtained through the introduction of Y6, which has a stronger photo harvesting capability in the spectral range from 750 to 950 nm than IT-4F, and higher short current density (Jsc) is observed in the ternary devices than in the binary device. Secondly, a rougher surface of the active layer is observed by increasing the Y6 concentration, which may result in an inferior exciton dissociation and charge transport process, the existence of larger-scaled crystal is proved by the GISAXS technology. Thirdly, the introduced Y6 can help to suppress the bimolecular recombination, which is in favor of the incremental device performance. Approximately 17.85% PCE improvement is obtained in comparison with PBDB-T-2F:IT-4F based binary OPVs.

High-performance ternary solar cells by introducing a medium bandgap acceptor with complementary absorption, reducing energy disorder and enhancing glass transition temperature

Ternary Organic Solar Cells with Efficiency >16.5% Based on Two Compatible Nonfullerene Acceptors.

Over 16.5% efficiency in ternary organic solar cells by adding an alloyed acceptor with energy transfer process

Boosting Photovoltaic Performance of Ternary Organic Solar Cells by Integrating a Multi-Functional Guest Acceptor

Highly Efficient Ternary Solar Cells with Efficient Förster Resonance Energy Transfer for Simultaneously Enhanced Photovoltaic Parameters

Simultaneously Decreasing the Bandgap and V oc Loss in Efficient Ternary Organic Solar Cells

Dual Non-Fullerene Acceptors Based High Efficiency Ternary Organic Solar Cells

Ternary Strategy Enabling High‐Performance Organic Solar Cells with Optimized Film Morphology and Reduced Nonradiative Energy Loss

High-Performance Ternary Organic Solar Cells through Incorporation of a Series of A 2 -A 1 -D-A 1 -A 2 Type Nonfullerene Acceptors with Different Terminal Groups

High-Performance Ternary Organic Solar Cells Enabled by Introducing a New A-DAD-A Guest Acceptor with Higher-Lying LUMO Level

Employing a Narrow-bandgap Mediator in Ternary Solar Cells for Enhanced Photovoltaic Performance.

A Near-Infrared Photoactive Morphology Modifier Leads to Significant Current Improvement and Energy Loss Mitigation for Ternary Organic Solar Cells

Exploiting Mechanism of Enhanced Charge Transfer in Ternary Organic Solar Cells at Low Energy Loss

18.7% Efficiency Ternary Organic Solar Cells Using Two Non-Fullerene Acceptors with Excellent Compatibility

Enhancing Intermolecular Packing and Light Harvesting through Asymmetric Non-Fullerene Acceptors for Achieving 18.7% Efficiency Ternary Organic Solar Cells

Enhancing Open-Circuit Voltage of High-Efficiency Nonfullerene Ternary Solar Cells with a Star-Shaped Acceptor.

Third component with a high LUMO energy level enables 17.69% efficiency in ternary organic solar cells

Two compatible non-fullerene acceptors towards efficient ternary organic photovoltaics

Molecular Interactions Regulation by Adding a Third Component with High Miscibility Suppresses the Energetic Disorder and Reduces Energy Loss for Efficient Ternary Solar Cells

Highly Efficient Ternary Solar Cells with Reduced Non-Radiative Energy Loss and Enhanced Stability Via Two Compatible Non-Fullerene Acceptors

High‐Performance Ternary Organic Solar Cells with Enhanced Luminescence Efficiency and Miscibility Enabled by Two Compatible Acceptors