Abstract:Background: The beam energy is one of the most significant parameters in particle therapy since it is directly correlated to the particles' penetration depth inside the patient. Nowadays, the range accuracy is guaranteed by offline routine quality control checks mainly performed with water phantoms, 2D detectors with PMMA wedges, or multi-layer ionization chambers. The latter feature low sensitivity, slow collection time, and response dependent on external parameters, which represent limiting factors for the quality controls of beams delivered with fast energy switching modalities, as foreseen in future treatments. In this context, a device based on solid-state detectors technology, able to perform a direct and absolute beam energy measurement, is proposed as a viable alternative for quality assurance measurements and beam commissioning, paving the way for online range monitoring and treatment verification. Purpose: This work follows the proof of concept of an energy monitoring system for clinical proton beams, based on Ultra Fast Silicon Detectors (featuring tenths of ps time resolution in 50 μm active thickness, and single particle detection capability) and time-of-flight techniques. An upgrade of such a system is presented here, together with the description of a dedicated self-calibration method, proving that this second prototype is able to assess the mean particles energy of a monoenergetic beam without any constraint on the beam temporal structure, neither any a priori knowledge of the beam energy for the calibration of the system. Methods: A new detector geometry, consisting of sensors segmented in strips, has been designed and implemented in order to enhance the statistics of coincident protons, thus improving the accuracy of the measured time differences. The prototype was tested on the cyclotron proton beam of the Trento Protontherapy Center (TPC). In addition, a dedicated self-calibration method, exploiting the measurement of monoenergetic beams crossing the two telescope sensors for different flight distances, was introduced to remove the systematic uncertainties independently from any external reference. Results: The novel calibration strategy was applied to the experimental data collected at TPC (Trento) and CNAO (Pavia). Deviations between measured and reference beam energies in the order of a few hundreds of keV with a maximum uncertainty of 0.5 MeV were found, in compliance with the clinically required water range accuracy of 1 mm. Conclusions: The presented version of the telescope system, minimally perturbative of the beam, relies on a few seconds of acquisition time to achieve the required clinical accuracy and therefore represents a feasible solution for beam commission, quality assurance checks, and online beam energy monitoring.

Monitoring electron and proton beam profiles with segmented silicon sensors

First experimental validation of silicon-based sensors for monitoring ultra-high dose rate electron beams

Characterization of CVD diamond detector with FLASH electron beam from modified LINAC accelerator

Silicon carbide detectors for dosimetry and monitoring of ultra-high dose rate beams

Test beam results of a fluorescence-based monitor for ultra-high dose rates

Comprehensive dosimetric characterization of novel silicon carbide detectors with UHDR electron beams for FLASH radiotherapy

Amorphous silicon detectors for proton beam monitoring in FLASH radiotherapy

Dosimetry of microbeam radiotherapy by flexible hydrogenated amorphous silicon detectors

Pulsed beam monitoring for electron FLASH

Development of a novel fibre optic beam profile and dose monitor for very high energy electron radiotherapy at ultrahigh dose rates

A fast plastic scintillator for low intensity proton beam monitoring

Hydrogenated amorphous silicon high flux x-ray detectors for synchrotron microbeam radiation therapy

Monocrystalline diamond detector for online monitoring during synchrotron microbeam radiotherapy

Mixed-field Radiation Monitoring and Beam Characterisation Through Silicon Diode Detectors

Calibration method and performance of a time-of-flight detector to measure absolute beam energy in proton therapy

Design and test of a compact beam current monitor based on a passive RF cavity for a proton therapy linear accelerator

Technical note: Measurement of the bunch structure of a clinical proton beam using a SiPM coupled to a plastic scintillator with an optical fiber

A Prototype Scintillator Real-Time Beam Monitor for Ultra-high Dose Rate Radiotherapy

Design of a new tracking device for on-line dose monitor in ion therapy

Silicon solid-state detectors for monitoring high-energy accelerator mixed field radiation environments

Radiation Measurements Using Timepix3 with Silicon Sensor and Bare Chip in Proton Beams for FLASH Radiotherapy