Abstract:Background Safe implementation and translation of FLASH radiotherapy to the clinic requirehs development of beam monitoring devices capable of high temporal resolution with wide dynamic ranges. Ideal detectors should be able to monitor LINAC pulses, withstand high doses and dose rates, and provide information about the beam output, energy/range, and profile. Purpose Two novel detectors have been designed and tested for ultra‐high dose‐rate (UHDR) monitoring: a multilayer nano‐structured 3‐layer high‐energy‐current (HEC3) detector, and a segmented large area, 4‐section flat (S4) detector with the goal of exploring their properties for a future combined design. Methods A Novalis‐TX LINAC was converted to produce a 10 MeV electron‐FLASH beam. Pulses were monitored using both HEC3 and S4 detectors. The HEC3 detector structure consisted of three electrode layers separated by a nanoporous aerogel (Aero): Al(50 μm)–Aero(100 μm)–Ta(10 μm)–Aero(100 μm)–Al(50 μm). The S4 structure was comprised of three layers: Cu(100 nm)–air(1 mm)–Al(100 nm) with contact potential for charge collection. Both detectors are self‐powered as they do not require an external voltage bias for charge collection. The beam was also characterized using a photodiode, Gafchromic EBT‐XD Film, OSLDs, and an Advanced Markus Chamber. Results The electron‐FLASH beam displayed a Gaussian‐like profile with 15 cm FWHM at isocenter. Electron‐FLASH dose rates up to an average of 260 Gy/s were measured on the surface of a solid water phantom at isocenter with an instantaneous dose rate of 1.8 × 105 Gy/s and a dose per pulse of up to 1 Gy/pulse. Both HEC3 and S4 detectors could record individual pulses for repetition rates of 360 Hz with a 4 μs pulse‐width. The HEC3 detector signal increased linearly with dose, MU, number of pulses, and dose rate up to 850 Gy/s with no loss of functionality at high doses or dose rates. The S4 detector showed linearity with MU and number of pulses at each of the four channels independently showing potential for spatial information and steering but lacked dose rate independence. Conclusions Two novel detectors, HEC3 and S4, successfully measured electron‐FLASH pulses and hence can be considered capable of electron‐FLASH beam monitoring in different capacities. HEC3 detector technology is suitable for monitoring high‐dose and UHDR beams with high temporal resolution required for pulse counting. We envision the combination of the HEC3 internal structure with the S4 piece‐wise design for real‐time monitoring of the temporal structure, spatial profiles, energy, and dosimetric properties of UHDR beams.

Silicon solid-state detectors for monitoring high-energy accelerator mixed field radiation environments

Mixed-field Radiation Monitoring and Beam Characterisation Through Silicon Diode Detectors

Amorphous silicon detectors for proton beam monitoring in FLASH radiotherapy

3-D thermal and radiation-matter interaction simulations of a SiC solid-state detector for neutron flux measurements in JSI TRIGA Mark II research reactor

Dosimetry of microbeam radiotherapy by flexible hydrogenated amorphous silicon detectors

First experimental validation of silicon-based sensors for monitoring ultra-high dose rate electron beams

Silicon carbide detectors for dosimetry and monitoring of ultra-high dose rate beams

Very-High-Energy Heavy Ion Beam Dosimetry using Solid State Detectors for Electronics Testing

SPM Bulletin 15

Comprehensive dosimetric characterization of novel silicon carbide detectors with UHDR electron beams for FLASH radiotherapy

Characterisation of silicon microstrip detectors for the ATLAS Phase-II Upgrade with a micro-focused X-ray beam

Detection resolving power of SiC Timepix3 detector to electrons, neutrons, ions and protons

Gamma dose rate monitoring using a Silicon Photomultiplier-based plastic scintillation detector

Development of a 3” LaBr3 SiPM-Based Detection Module for High Resolution Gamma Ray Spectroscopy and Imaging

Hydrogenated amorphous silicon high flux x-ray detectors for synchrotron microbeam radiation therapy

Development of a silicon carbide radiation detection system and experimentation of the system performance

Front End Electronics for Radiation Detectors Based on SiC: Application to High Dose per Pulse Charged Particle Beam Current Measurement

Characterization of a medium-sized CLLB scintillator: single neutron/gamma detector for radiation monitoring

A fast plastic scintillator for low intensity proton beam monitoring

Pulsed beam monitoring for electron FLASH

Photomultipliers as High Rate Radiation-Resistant In-Situ Sensors in Future Experiments