Abstract:This study aims at introducing the back stress of anisotropic strain-hardening into the crystal plasticity theory and demonstrating the rationality of this crystal plasticity model to describe the evolution of the subsequent yield surface of polycrystalline aluminum at the mesoscopic scale under complex pre-cyclic loading paths. By using two different scale finite element models, namely a global finite element model (GFEM) as the same size of the thin-walled tube specimen used in the experiments and a 3D cubic polycrystalline aggregate representative volume element (RVE) model, the evolution of the subsequent yield surface for different unloading cases after 30 pre-cycles is further performed by experiments and numerical simulations within a crystal plasticity finite element (CPFE) frame. Results show that the size and shape of the subsequent yield surfaces are extremely sensitive to the chosen offset strain and the pre-cyclic loading direction, which present pronounced anisotropic hardening through a translation and a distortion of the yield surface characterized by the obvious "sharp corner" in the pre-deformation direction and "flat" in the reverse direction by the definition of small offset strain, while the subsequent yield surface exhibits isotropic hardening reflected by the von Mises circle to be distorted into an ellipse by the definition of large offset strain. In addition, the heterogeneous properties of equivalent plastic strain increment are further discussed under different offset strain conditions. Modeling results from this study show that the heterogeneity of plastic deformation decreases as a law of fraction exponential function with the increasing offset strain. The above analysis indicates that anisotropic hardening of the yield surface is correlated with heterogeneous deformation caused by crystal microstructure and crystal slip. The crystal plasticity model based on the above microscopic mechanism can accurately capture the directional hardening features of the yield surface.

Study on plastic yield surfaces of pyramidal lattice materials with circular and rectangular cross-sections

Study of Equivalent Mechanical Properties on Pyramidal Lattice Materials

Yield Surfaces and Plastic Flow of 45 Steel under Tension-Torsion Loading Paths

Effective elastic properties and initial yield surfaces of two 3D lattice structures

A Study on Effective Compressive and Shear Properties of Tetrahedral Lattice Materials

Anisotropic yielding model of lattice material and influencing factors

Plastic yield and collapse mechanism of planar lattice structures

Effects of High Order Deformations on the Strength of Planar Lattice Materials

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Study on Buckling Behavior of Multilayer Pyramid Lattice Structures

Subsequent Yield and Plastic Flow Analysis of Polycrystalline Copper under Biaxial Loading

Investigation of Yield Surfaces Evolution for Polycrystalline Aluminum after Pre-Cyclic Loading by Experiment and Crystal Plasticity Simulation

ANALYSIS OF YIELD SURFACE AND CRACK TIP PLASTIC ZONE OF KAGOME LATTICE STRUCTURE

Mechanical characterization and constitutive modeling of additively-manufactured polymeric materials and lattice structures

Yield surfaces and micro-failure mechanism of block lattice truss materials

Finite element analysis on yield surface evolution of cellular materials

Investigation of Surface Curvature Distribution Characteristic on the Mechanical Properties of 3D Printed Lattice Structures

The Effect of Poisson Ratio of Material Properties on Plastic Yield

Effect Of Yield Surface Curvature On Local Necking In Biaxially Stretched Sheets In Porous Materials

Design, Mechanical Properties and Optimization of Lattice Structures with Hollow Prismatic Struts

Plastic Zone of Semi-Infinite Crack in Planar Kagome and Triangular Lattices