Elemental redistribution and precipitation reactions of 9Cr1.5Mo1CoB(FB2) steel during tempering
Yongqiang Zhang,Jianfeng Gu,Lizhan Han
DOI: https://doi.org/10.1016/j.matchar.2020.110778
IF: 4.537
2021-01-01
Materials Characterization
Abstract:The effect of tempering temperature on the precipitation reactions and elemental redistribution in 9Cr1.5Mo1CoB(FB2) steel has been studied using scanning electron microscope(SEM), transmission electron microscope(TEM), secondary ion mass spectrometry(Tof-SIMS) and atom probe technique (APT). The results show that water-cooling from normalization at 1100 °C produced lathy martensite. During tempering at 500 °C, only C and B atoms were segregated, and formed needle-like Fe3(C, B); After tempering at 600 °C, the segregation of Cr, Mo and Mn showed noticeable difference, forming Cr + Mn + Mo + C + B and Mo + Cr + C + B clusters. Consequently, (Cr,Mo)2(C,B), Cr-rich M7(C,B)3 and Cr-rich M23(C,B)6 were observed in sample tempered at 600 °C. And both (Cr,Mo)2(C,B) and M7(C,B)3 particles were entirely replaced by Cr-rich M23(C,B)6 by enhancing the tempering temperature to 700 °C. Therefore, the evolution of carbides in FB2 steel during tempering at 500 °C–700 °C can be summarised as follows: Fe3(C,B) → (Cr,Mo)2(C,B) + Cr-rich M7(C,B)3 → Cr-rich M23(C,B)6. Besides, the Mo element in (V,Nb,Mo)(N,C) particles was gradually replaced by V and Nb with the increase of temperature from 600 °C to 700 °C. While Si and Co were rejected to the interfaces of carbides/matrix during tempering, forming a flux of Si and Co. Then, this flux may suppress carbides coarsening by retarding the diffusion of Cr, Mo and Mn from the matrix into carbides.