Abstract:The main goal of this research is to develop a low-cost scalable continuous manufacturing platform for Ni-rich cathodes. In this work, we demonstrate the synthesis and electrochemical performance of Ni-rich layered oxide [Li[Ni 0.8 Mn 0.1 Co 0.1 ]O 2 (NMC811)], an efficient low-cobalt cathode for the next generation lithium-ion batteries using a three-phase slug-flow reactor. 1-5 The slug flow reactor is used to continuously produce uniform, high purity NMC811 with spherical morphology using oxalate precursor chemistry. The precursor material is then reacted with Li salts to prepare high purity cathode materials. The as-prepared NCM811 possess a high tap density of 2.4 g mL-1 and a high specific capacity of 202 mAh g-1 at 0.1C. 5 A novel coating method has been developed to produce a stable LiF layer on the cathode surface to improve the cycling stability of the material. 6 This work will discuss in detail about the synthesis procedure, microstructural and electrochemical performance of the cathode material produced by the slug flow manufacturing process. This demonstration provides a pathway towards scaling up the cathode synthesis process for large-scale energy storage applications. 3 Acknowledgements This research was supported by the U.S. Department of Energy, Office of Energy Efficiency and Renewable Energy, Advanced Materials and Manufacturing Technologies Office, the National Science Foundation (Grant No. CMMI-1940948). Battery testing research was supported by the U.S. Department of Energy, Office of Science, Basic Energy Sciences, Materials Sciences and Engineering Division. References Mou, A. Patel, S. Mallick, B. P. Thapaliya, M. P. Paranthaman, J. Mugumya, M. L. Rasche, R. B. Gupta, S. Saleh, S. Kothe, E. Baral, G. P. Pandey, H. Lopez, M. Jiang, “Scalable advanced Li(Ni 0.8 Co 0.1 Mn 0.1 )O 2 cathode materials from a slug-flow continuous process,” ACS Omega 7 (46) 42408-42417 (2022) Jiang, Z. Zhu, E. Jimenez, C. D. Papageorgiou, J. Waetzig, A. Hardy, M. Langston and R. D. Braatz. “Continuous-flow tubular crystallization in slugs spontaneously induced by hydrodynamics”. Cryst. Growth Des. 14, 851–860 (2014). Mou, and M. Jiang. “Fast continuous non-seeded cooling crystallization of glycine in slug flow: Pure α-form crystals with narrow size distribution”. J. Pharm. Innov. 15, 281–294 (2020). Mallick, A. Patel, X-G. Sun,M. P. Paranthaman, M. Mou, J. Mugumya, M. Jiang, M. L. Rasche, H. Lopez, and R. B. Gupta, "Low-cobalt active cathode materials for high-performance lithium-ion batteries: synthesis and performance enhancement methods," J. Mater. Chem. A 11, 3789-3821 (2023). Mou, A. Patel, S. Mallick, K. Jayanthi, X. -G. Sun, M. P. Paranthaman, S. Kothe, E. Baral, S. Saleh, J. H. Mugumya, M. L. Rasche, R. B. Gupta, H. Lopez, M. Jiang, Slug-flow co-precipitation synthesis of uniformly-sized oxalate precursor microparticles for good reproducibility, tap density, and electrochemical performance of Li(Ni0.8Co0.1Mn0.1)O2 cathode materials, ACS. Appl. Energy Mater. , 2023, 6, 3213−3224. Xiao-Guang Sun, Charl J Jafta, Susheng Tan, Albina Borisevich, Ram B Gupta, Mariappan Parans Paranthaman, "Facile surface coatings for performance improvement of NMC811 battery cathode materials, "J. Electrochem. Soc. 169 (2) 020565 (2022).

Slug-flow synthesis of NCMA: Effect of substitution of cobalt with aluminum on the electrochemical performance of Ni-rich cathode for lithium-ion battery

Enhancing high-voltage performances of nickel-based cathode material via aluminum and progressive concentration gradient modification

Synthesis of LiNiO2 cathode materials with homogeneous Al doping at the atomic level

Effects of Al Content on the Electrochemical Performance and Thermal Stability of Li(Ni0.9Co0.06Mn0.04)1−xAlxO2 Cathode Materials for Li-ion Batteries

(Invited) Delineating the Intricacies Involved in the Synthesis of Cobalt-Free High-Nickel Layered Oxide Cathodes for Lithium-Ion Batteries

Effects of Al doping on the electrochemical performances of LiNi0.83Co0.12Mn0.05O2 prepared by coprecipitation

Al Substitution for Mn during Co-Precipitation Boosts the Electrochemical Performance of LiNi 0.8 Mn 0.1 Co 0.1 O 2

Enhanced lithium storage capability of Ni-rich LiNi0.9CoxMn0.1−xO2(0 ≤ x ≤ 0.1) cathode by co-operation of Al-doping and V-coating

(Invited) Slug-Flow Manufacturing of Uniform and Tunable Battery Cathode Materials

Synthesis of Single Crystal LiNi0.92Co0.06Mn0.01Al0.01O2 Cathode Materials with Superior Electrochemical Performance for Lithium Ion Batteries

An In-Depth Understanding of the Effect of Aluminum Doping in High-Nickel Cathodes for Lithium-Ion Batteries

Influence of Al doping on the structure and electrochemical performance of the Co-free LiNi 0.8 Mn 0.2 O 2 cathode material

Substantial Doping Engineering in Layered LiNi0.5+xCo0.2−xMn0.3O2 Materials for Lithium-Ion Batteries

In Situsynthesis Of A Nickel Concentration Gradient Structure Of Ni-Rich Lini(0.8)Co(0.15)Al(0.05)O(2)With Promising Superior Electrochemical Properties At High Cut-Off Voltage

Synthesis of Single Crystal LiNi 0.92 Co 0.06 Mn 0.01 Al 0.01 O 2 Cathode Materials with Superior Electrochemical Performance for Lithium Ion Batteries

Substantial Doping Engineering in Layered LiNi 0.5+x Co 0.2−x Mn 0.3 O 2 Materials for Lithium-Ion Batteries

Understanding the Feasibility of Manganese Substitution for Cobalt in the Synthesis of Nickel-Rich and Cobalt-Free Cathode Materials

Enhanced electrochemical performance of Ni-rich cathode material by N-doped LiAlO2 surface modification for lithium-ion batteries

Effect of Zr–Y Double Doping and Al2O3 Coating on Properties of Nickel-Rich Monomer LiNi0.6Co0.2Mn0.2O2 Cathode Material for Li-Ion Batteries

High structure stability and Li-conduction of LiNi0.8Co0.1Mn0.1O2 cathode co-coated by Al2O3 and LiNbO3 for high performance lithium-ion battery

Scalable Advanced Li(Ni0.8Co0.1Mn0.1)O2 Cathode Materials from a Slug Flow Continuous Process