Abstract:Isostructural alloying has been regarded as an important approach to boosting thermoelectric performance of narrow gap semiconductors through thermal conductivity reduction. However, it does harm to carrier mobilities as well because of atomic disorders. Here, we extend the alloying concept from "isostructural" to "quasi-isostructural", which means that the two alloying components are no longer strictly isostructural but structurally closely related. As a proof-of-concept, a series of cubic Cu2SnSe3–tetragonal Cu3SbSe4 quasi-isostructural alloys (Cu2+xSn1–xSbxSe3+x) were synthesized, and their thermoelectric transport properties were systematically studied. No significant loss of carrier mobilities was found during quasi-isostructural alloying, probably due to the structural similarity of the two end members as well as the negligible mass contrasts between Sn and Sb. Surprisingly, a remarkable reduction of lattice thermal conductivity from 1.2 W m–1 K–1 for Cu2SnSe3/Cu3SbSe4 to 0.4 W m–1 K–1 for Cu5SnSbSe7 at 673 K was observed, which can hardly be explained from a solid solution perspective. Our X-ray photoelectron spectroscopy analysis unambiguously demonstrate the coexistence of Sn2+ and Sn4+ in the alloying systems, whereas Sn simply exhibits Sn4+ in Cu2SnSe3. We deduce that the minute structural changes of Cu2SnSe3 during quasi-isostructural alloying make Sn discordant, leading to its valence state splitting. The mixed-valence scattering therefore strongly impedes phonon propagation beyond alloying. Altogether, a considerably enhanced ZT ≈ 0.4 is realized in the sample with x = 0.2, which is 150% improvement over the x = 0 sample. By selecting the x = 0.5 sample as a representative, a preliminary doping study was performed but seems unsuccessful because of the varying Sn2+/Sn4+ ratio. We expect higher thermoelectric performance in those quasi-isostructural alloys if their carrier concentration can be fully optimized.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.1c01155?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.1c01155</a>.Temperature-dependent heat capacity (Cp), thermal diffusivities (D) and Lorenz number (L) for Cu2+xSn1–xSbxSe3+x (x = 0, 0.2, 0.5, 0.8, and 1.0). The longitudinal (νl) and transverse (νt) acoustic velocities, calculation of average acoustic velocity (vs) (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.1c01155/suppl_file/ae1c01155_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Alloying Cr 2/3 Te in AgCrSe 2 compound for improving thermoelectrics

Structural transformation and thermoelectric performance in Ag2Te1−Se solid solution

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Co-alloying of Sn and Te enables high thermoelectric performance in Ag9GaSe6

Enhancement of Thermoelectric Performance of Layered SnSe2 by Synergistic Modulation of Carrier Concentration and Suppression of Lattice Thermal Conductivity

Ultralow Lattice Thermal Conductivity and Superior Thermoelectric Performance in AgAlS2 and AgAlSe2

Scattering Mechanisms and Compositional Optimization of High‐Performance Elemental Te as a Thermoelectric Material

Ternary Ag2Se1- xTex: A Near-Room-Temperature Thermoelectric Material with a Potentially High Figure of Merit

Band convergence and nanostructure modulations lead to high thermoelectric performance in SnPb0.04Te-y% AgSbTe2

Rational design and synthesis of Cr 1-x Te/Ag 2 Te composites for solid-state thermoelectromagnetic cooling near room temperature

Dual Alloying Enables High Thermoelectric Performance in AgSbTe2 by Manipulating Carrier Transport Behavior

Improved Thermoelectric Performance of Tellurium by Alloying with a Small Concentration of Selenium to Decrease Lattice Thermal Conductivity

Ag Interstitial Inhibition and Phonon Scattering at the ZnSe Nano-Precipitates to Enhance the Thermoelectric Performance of Ag 2 Se

Anionic regulation and valence band convergence boosting the thermoelectric performance of Se-alloyed GeSb 2 Te 4 single crystal

Quasi-isostructural Alloying of Cu 2 SnSe 3 –Cu 3 SbSe 4 toward Higher Thermoelectric Performance

Superior thermoelectric properties of ternary chalcogenides CsAg5Q3 (Q = Te, Se) predicted using first-principles calculations

Band flattening and phonon-defect scattering in cubic SnSe–AgSbTe2 alloy for thermoelectric enhancement

Remarkable effects of shear-exfoliation and restacking on microstructural texturing and thermoelectric properties of AgCrSe2

High thermoelectric properties of Cu2Te Ag2Te composite with Fe addition and non-stoichiometric Te

Achieving Superior Thermoelectric Performance in Ge4Se3Te Via Symmetry Manipulation with I–V–VI2 Alloying

Thermoelectric Properties of Low Te Concentration‐Doped Cu2ZnSnSe4‐Based Quaternary Alloys