Abstract:Silver selenide (Ag 2 Se) stands out as a promising thermoelectric (TE) material, particularly for applications near room temperatures. This research presents a novel approach for the fabrication of bulk Ag 2 Se samples at a relatively low temperature (170°C) using the cold sintering process (CSP) with AgNO 3 solution as a transient liquid agent. The effect of AgNO 3 addition during CSP on the microstructure and TE properties was investigated. The results from phase, composition and microstructure analyses showed that the introduction of AgNO 3 solution induced the formation of Ag nano-precipitates within the Ag 2 Se matrix. Although the nano-precipitates do not affect the phase and crystal structure of orthorhombic β-Ag 2 Se, they suppressed crystal growth, leading to reduced crystallite sizes. The samples containing Ag nano-precipitates also exhibited high porosity and low bulk density. Consequently, these effects contributed to significantly enhanced electrical conductivity and a slight decrease in the Seebeck coefficient when small Ag concentrations were incorporated. This resulted in an improved average power factor from ∼1540 μW·m −1 ·K −2 for pure Ag 2 Se to ∼1670 μW·m −1 ·K −2 for Ag 2 Se with additional Ag precipitates. However, excessive Ag addition had a detrimental effect on the power factor. Furthermore, thermal conductivity was effectively suppressed in Ag 2 Se fabricated using AgNO 3 -assisted CSP, attributed to enhanced phonon scattering at crystal interfaces, pores, and Ag nano-precipitates. The highest figure-of-merit ( zT ) of 0.92 at 300 K was achieved for the Ag 2 Se with 0.5wt% Ag during CSP fabrication, equivalent to >20% improvement compared to the controlled Ag 2 Se without extra Ag solution. Thus, the process outlined in this study presents an effective strategy to tailor the microstructure of bulk Ag 2 Se and enhance its TE performance at room temperature.

Ag Interstitial Inhibition and Phonon Scattering at the ZnSe Nano-Precipitates to Enhance the Thermoelectric Performance of Ag 2 Se

Enhancement of Thermoelectric Performance of Layered SnSe2 by Synergistic Modulation of Carrier Concentration and Suppression of Lattice Thermal Conductivity

Enhanced thermoelectric performance of Cu2Se thin film derived from potential barrier scattering by incorporating SnSe nano-dispersions

Independently Tuning the Power Factor and Thermal Conductivity of SnSe Via Ag2S Addition and Nanostructuring

Enhanced Thermoelectric Properties of Cu2SnSe3-Based Materials with Ag2Se Addition

AgSbSe2 inclusions enabling high thermoelectric and mechanical performance in n-type Ag2Se-based composites

Suppressing Ag2Te Nanoprecipitates for Enhancing Thermoelectric Efficiency of AgSbTe2

Synthesis and Thermoelectric Properties of Ag-Doped Snse

Ag, Pb co-doped SnSe high performance thermoelectric materials

Boosting thermoelectric efficiency of Ag2Se through cold sintering process with Ag nano-precipitate formation

Structural transformation and thermoelectric performance in Ag2Te1−Se solid solution

High Thermoelectric Performance in Polycrystalline SnSe Via Dual‐Doping with Ag/Na and Nanostructuring with Ag8SnSe6

Liquid-Phase Manipulation Securing Enhanced Thermoelectric Performance of Ag 2 Se

Enhanced thermoelectric properties of Cu-Se system via bond-structure adjustment by Ag-doping

Thermoelectric Ag 2 Se: Imperfection, Homogeneity, and Reproducibility

Dynamical Ag-Intercalation with AgSnSe2 Nano-Precipitates in Cl-Doped Polycrystalline SnSe2 toward Ultra-High Thermoelectric Performance

Decoupled electron-phonon transport in Ag2Se thermoelectric materials through constructing TiO2/MoS2 co-decorated cell-membrane-mimic grain boundaries

Enhanced Thermoelectric Performance in Cu2GeSe3 Via (Ag,ga)-Co-doping on Cation Sites

Enhancing the Thermoelectric Performance of Cu2se Via Ag Doping

High Thermoelectric Properties for Sn-doped AgSbSe 2

The electronic-thermal transport properties and the exploration of magneto-thermoelectric properties and the Nernst thermopower of Ag2(1+)Se