Abstract:Lightweight, carbon fibre reinforced composites are often employed for the manufacture of aerospace components due to their good strength to weight ratio. However, due to poor interlaminar strength, composite components are prone to barely visible impact damage, caused by low velocity impacts, during aircraft operation. Guided-wave-based structural health monitoring (SHM) techniques, using a network of distributed sensors, is an important Structural Health Monitoring (SHM) tool for the detection and localization of in-service impact damage in composite structures. However, the material anisotropy of composite laminates influences guided wave propagation and scattering. These anisotropic effects, if unaccounted for, could lead to inaccurate localization of damage, and potential regions of the structure where guided waves cannot propagate with sufficient amplitude, reducing damage sensitivity. Defect characterization can be improved by considering the scattering characteristics of various damage types for the sparse array signal processing. Guided wave scattering (A0 Lamb wave mode) was investigated around an artificial insert delamination in a quasi-isotropic CFRP panel. Permanent magnets, mounted on an undamaged region of the plate, were also used as scattering targets and compared to the delamination case. Full 3D Finite Element (FE) simulations were performed for both the delamination and magnet cases and compared to wavefield data obtained from non-contact laser Doppler vibrometer (LDV) measurements. Individual ply layers were modelled using unidirectional composite material properties to accurately capture the anisotropy effects. Good agreement was found between the experimental measurements and simulations. Scattered guided wave amplitudes around each damage type show strong directional dependency with energy focusing along the fiber directions of the outer ply layers of the laminate. Distinct scattering behavior was observed for each damage type. Implications of anisotropy and angular scattering on sparse array SHM of different defect types are discussed.

Wave propagation through alumina-porous alumina laminates

Fabrication and Characterisation of Alumina/aluminium Composite Materials with a Nacre-Like Micro-Layered Architecture

Contact damage response of alumina-based layered architectures under different loading configurations

Low-Velocity Impact Property of Alumina/Epoxy/Metal Laminated Composites

Dynamic Properties and Damage Pattern of A95 Ceramic under Low-Impact Velocity

Assessment of Multilayered Plates with Hyperelastic Coatings Subjected to Dynamic Loadings by Impact at Low Velocities

Failure Analysis and Piezo-resistance Response of Intralaminar Glass/Carbon Hybrid Composites Under Blast Loading Conditions

Effect of Sinusoidal Fiber Waviness on Non-Linear Dynamic Performance of Laminated Composite Plates with Variable Fiber Spacing

Experiment Analysis of Impact Damage of Laminated Composite Shells

Scattering of guided waves at delaminations in composite plates

Dynamic mechanical properties and wave propagation of composite rock-mortar specimens based on SHPB tests

Research on dynamic mechanical behavior and damage evolution mechanism of Cu/WCp laminated composites

Dynamic Response Behaviours of Al2O3 Ceramics with Different Grain Sizes under SHPB Compression Loading

In Situ Investigation of Strain Localization in Sintered, Porous Segmented Alumina

Design of Interfaces for Optimal Mechanical Properties in Al2O3/Mo Laminated Composites

Stress-wave propagation in multilayered and density-graded viscoelastic medium

Stress Wave Propagation in Piezoelectric Fiber Reinforced Laminated Composites Subjected to Thermal Shock

The Effects of Load and Frequency on the Fatigue Damage of Bi-Layered Zirconia and Alumina Dental Composites

Experimental and Numerical Investigation of the Ballistic Response of Alumina 99.7% Covered with Aluminum 6061-T6 Face Sheets

Preparation and Mechanical Properties of Al2O3/Al Laminated Ceramic Matrix Composites

Guided Ultrasonic Wave Monitoring of Damage in Anisotropic Composites