Abstract:<p>Quantitative characterization of subsurface defects is a challenging problem in eddy current testing (ECT), not only due to the limitation of the penetration depth of eddy currents, but also due to the ill-posed nature of the inverse problem associated with quantifying a defect's 3D dimensions and its location in the test sample from measurements made on the sample surface. This paper presents a new ECT method for subsurface defect detection and quantification. Eddy currents with continuously varying frequency in a selected frequency band is induced in the conductive sample by using a chirp modulated excitation scheme. The frequency band of the chirp waveform is chosen so that the penetration depth of eddy current in the selected frequency band covers the thickness of the sample under test. The presence of a defect will disturb the distribution of the induced eddy currents. This disturbance is measured in terms of a varying magnetic field using an array of tunneling magneto-resistance (TMR) sensors. A C-scan image is obtained by linearly scanning the specimen. The footprint of the defect is calculated using spatial features of the C-scan image while the depth of the defect is estimated by analyzing the frequency characteristics of the measured chirp signal. A three-dimensional estimate of the dimensions of any subsurface defect can be obtained using the empirical procedure. The operating principle of this method is studied with a finite element method (FEM) model and then validated experimentally with a prototype array probe consisting of 180 TMR sensors. Thanks to its high sensitivity, the TMR sensors are suitable for measuring the weak low frequency magnetic field signal caused by a deep defect. The spacing between each two adjacent sensors is as small as 0.5 mm providing a magnetic field image with fine spatial resolution, which is beneficial for defect quantification. An aluminum sample with embedded defects was tested using the prototype probe. It is seen that the proposed scheme utilizing spatial and frequency domain features is capable of quantitatively characterizing subsurface defects.</p>

Reconstruction of Metal Defect Images Based on the Sensitivity Matrix of High Conductivity Initial Estimate for Eddy Current Tomography

Quantifying Hidden Defect In Multi-Layered Structures By Using Eddy Current System Combined With A Scanner

Image Reconstruction Algorithm for Capacitively Coupled Electrical Resistance Tomography

Induced Current Thermo-Electrical Impedance Tomography for Nonferromagnetic Metal Material Surface Defect Profile Reconstruction

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Deep Defects Evaluation of Conductive Materials Based on Eddy Current Nondestructive Testing with GMR sensor

Inspection of defects in conductive multi-layered structures by an eddy current scanning technique: Simulation and experiments

Online defect detection on metallic plates using electromagnetic tomography

Quantitative Nondestructive Estimation of Deep Defects in Conductive Structures

Eddy Current Probe With Three-Phase Excitation and Integrated Array Tunnel Magnetoresistance Sensors

Detection of Surface and Back-Surface Defects on Metal Plate via Rectangular Wave Eddy Current Testing Using Magnetoresistive Sensor

Defect detection of metallic samples by electromagnetic tomography using closed-loop fuzzy PID-controlled iterative Landweber method

Eddy Current Test/ultrasonic Testing Integrative Method for Detecting Sub-Surface Defects in Conductive Structures

Sensitivity Matrix Construction Based on Ultrasound Modulation for Electrical Resistance Tomography

Vector Magnetic Field Imaging With High-Resolution TMR Sensor Arrays for Metal Structure Inspection

Sparse Defects Detection and 3D Imaging Base on Electromagnetic Tomography and Total Variation Algorithm

Frequency domain analysis of magnetic field images obtained using TMR array sensors for subsurface defect detection and quantification

DC-Biased Magnetization Based Eddy Current Thermography for Subsurface Defect Detection.

Image Reconstruction Algorithms for Electrical Capacitance Tomography

Reconstruction of Cracks with Multiple Eddy Current Coils Using A Database Approach

A Numerical Investigation of an Eddy Current Sensor for Detecting Small Defects in Metal Additive Manufacturing