Abstract:Abstract. We present an exploratory study carried out with a new miniature portable emission measurement system (Mini-PEMS) specifically designed at the Technical University of Liberec (CZ) for applications on 2-wheeler vehicles owing to its reduced size (45 x 30 x 20 cm) and weight (≈ 15 kg). It measures the exhaust gas concentrations of hydrocarbons, carbon monoxide and dioxide with non-dispersive infrared method, nitrogen mono- and di-oxides and oxygen using an electrochemical cell. In addition, the instrument acquires the engine speed, the manifold absolute pressure, the inlet and exhaust gas temperature, the geo-localization and vehicle speed. The exhaust mass flow rate is calculated from engine and emission data. The Mini-PEMS was validated on three 2-wheelers (1 moped and 2 motorcycles) against laboratory-grade instrumentation in the Vehicle Emissions Laboratory of the European Commission in terms of measured concentrations, exhaust flow, fuel consumption and mass emission of pollutants. The mean absolute deviations of gas concentrations were 8 % for HC, 8 % for CO, 13 % for NOx and 2 % for CO2 while the mass emissions (which include the exhaust flow determination uncertainty) were 7 % for HC, 7 % for CO, 9 % for NOx and 5 % for CO2. An agreement of 2 % was achieved between the fuel consumption measured in the laboratory and calculated by the Mini-PEMS. As an application, the instrument was tested on board of the vehicles during on-road trips. The emissions measured on-road were consistent among repeated runs, with differences between laboratory and on-road tests much larger than those between Mini-PEMS and laboratory. We found similar or larger HC and NOx real-driving emissions, larger CO from motorcycles and smaller for the moped. Considering its size and weight, the Mini-PEMS proved to be an efficient tool for vehicle monitoring, research and development and could be tested for in-service monitoring applications related to carbon monoxide and nitrogen oxides emissions. A tentative approach to characterize particulate mass and particle number was presented and compared to the existing non-volatile particle number protocol.

Method and apparatus for monitoring a arranged in the exhaust system of an internal combustion engine, the particulate filter

Methodology of diesel particulate filter testing on test bed for non-road engine application

Electrostatic vehicle exhaust particle sensor for the evaluation of the diesel particulate filter (DPF)

Apparatus and method for measuring particulate matter by optical method

A miniature Portable Emissions Measurement System (PEMS) for real-driving monitoring of motorcycles

Engine operating method and crankcase ventilation system

Portable Digital Holographic Particle Analyzer (DHPA) for Pneumatically Conveyed Fuel Monitoring: Design and Validation

A Real-Time Approach to Detect PM2.5 in a Seriously Polluted Environment Based on Pressure Drop

A portable fiber-optic chemical device for the quantitative determination of carbon monoxide from automobile exhaust emissions

Structural simulation and performance evaluation of self-priming electrostatic diesel vehicle emission particle sensor

The Methodologies and Instruments of Vehicle Particulate Emission Measurement for Current and Future Legislative Regulations

A New Approach for Very Low Particulate Mass Emissions Measurement

Study on the purification of diesel engine exhaust particles based on water film adsorption

REMPI Analysis of Air Pollutants Caused by Car Exhaust

Car following testing system and method for heavy duty car exhaust gas emission

Dilution Sampling System of Particulate Measurement for Automotive Diesel Engine

Application of Filter Type Smoke Meter to Diesel Engine Particulate Emission Control

Design and evaluation of a portable PM2.5 monitor featuring a low-cost sensor in line with an active filter sampler

Review of the State-of-the-art of Exhaust Particulate Filter Technology in Internal Combustion Engines

Design and Implementation of Vehicle Exhaust Gas Analyzer in NDIR Method

STUDY ON FREQUENCY BAND ANALYSIS AND FILTERING FOR PRESSURE SIGNAL IN ENGINE CYLINDER