Comparison of principal component regression (PCR) and partial least square regression (PLSR) modeling methods for quantifying polyethylene (PE) in recycled polypropylene (rPP) with near-infrared spectrometry (NIR)
Pixiang WangKe ZhanXueqi WangYucheng PengHaixin PengYifen WangShaoyang Liua Center for Materials and Manufacturing Sciences,Departments of Chemistry and Physics,Troy University,Troy,Alabama,USAb College of Forestry,Wildlife and Environment,Auburn University,Auburn,Alabama,USAc Department of Biosystems Engineering,Auburn University,Auburn,Alabama,USA
DOI: https://doi.org/10.1080/1023666x.2024.2306428
2024-01-29
International Journal of Polymer Analysis and Characterization
Abstract:Recycled polypropylene (rPP) often contains a small amount of polyethylene (PE). Since polypropylene (PP) and PE are incompatible, the presence of PE compromises the performance of rPP materials and needs to be closely monitored. In our previous work, Raman and near-infrared (NIR) spectrometries were evaluated to monitor PE content in rPP with partial least square regression (PLSR) modeling. The NIR spectrometry exhibited a wider application range, but the accuracy of the prediction models might be further improved. In the current work, a different modeling method, principal component regression (PCR) was employed to analyze PE content in rPP with NIR spectrometry. Spectrum pretreatment methods, including multivariate scatter correction (MSC), standard normal variate transformation (SNV), smoothing, and first derivative, were investigated to improve the NIR spectrum quality. Forward and backward interval methods were used to optimize spectral range selection. The outcomes were compared with our previous PLSR modeling results. The highest accuracy in independent validation was achieved by a PCR model with an R 2 of 0.9991 and a root-mean-square error of prediction (RMSEP) of 0.1596 PE%. On the other hand, a PLSR model achieved the lowest RMSEP of 0.9712 PE% for a non-colored post-consumer rPP sample. The PCR models might be sensitive to interference and more suitable for post-industrial materials, which have a simpler chemical composition. The PLSR models might have better stability and be more suitable for complicated post-consumer samples. Both the PCR and PLSR models were successfully applied to a gray commercial rPP sample.
polymer science