Formation of the Heterojunction Based on Titania Modified with Ni and Ag Sulfide Via SILAR Method - Electrochemical and Photoelectrochemical Activity
Wiktoria Lipinska,Manjunath Shinnur,Katarzyna Grochowska,Ryan Crisp,Katarzyna Siuzdak
DOI: https://doi.org/10.1149/ma2023-02582835mtgabs
2023-12-22
ECS Meeting Abstracts
Abstract:The great interest of TiO 2 nanotubes (TiNT) is justified by large surface area, high degree of ordering, facilitated charge transport along the nanotube, mechanical strength, strong UV absorption and light scattering due to the pore specific arrangement well as wide range of potential applications in solar cells, photocatalysis and sensors [1]. However, due to the wide energy band gap of TiO 2 (3.2 eV) its photoactivity is limited and therefore titania based heterojunction are formed with the photoabsorber being active in the visible range [2]. In line with this strategy, we present electrochemical and photoelectrochemical activity of TiNT modified by NiS and AgS. The electrode is fabricated via electrochemical anodization of Ti foil, thermal annealing providing anatase phase and finally Successive Ionic Layer Adsorption and Reaction (SILAR) was carried out using silver, nickel and sulfur ions precursor and with different number of deposition cycles. The characteristic Ag-S, Ag-O and S-O peaks appearing on Raman spectra indicating successful SILAR modification. The cyclic voltammetry curves for TiNT, NiS/TiNT, AgS/TiNT and AgS/NiS/TiNT electrode were registered in 0.5 M Na 2 SO 4 (Fig.1a). Peaks found on the anodic branch of the AgS/NiS/TiNT electrode at 0 V and +0.3 V vs. Ag/AgCl/0.1 M KCl are assigned to oxidation of Ag 0 to Ag 1+ and Ag 1+ to Ag 2+ , respectively. When the scan went towards cathodic direction, peak located at +0.1 V and -0.1 V indicates reduction of Ag 2+ to Ag 1+ and Ag 1+ to Ag 0 , respectively [3]. Furthermore, the linear voltammetry measurements performed under visible light illumination in 0.5 M Na 2 SO 4 is presented in Fig.1b. The best photoactivity was reached for the AgS/NiS/TiNT electrode when only 5 deposition cycles for each metal precursor was applied. The photocurrent registered at +0.5 V reaches ca. 40 μA/cm 2 which is 20 times higher than for pure TiNT. Summing up, modification of titania nanotubes by nickel and silver sulfides significantly enhanced material photoelectrochemical response under visible light. Moreover, it has been proved that this synergetic effect originated from the titania/metal sulphide heterojunction that can be achieved using SILAR method. Research is financed by National Science Centre (Poland): Grant no. 2020/39/I/ST5/01781 [1] K. Siuzdak et al. RSC Advances, 5 (2015) 50379, DOI:10.1039/c5ra08407e [2] S. Chandrasekaran et al. Chemical Society Reviews, 48 (2019) 4178, DOI:10.1039/c8cs00664d [3] J.R.N. Santos et al. Electrocatalysis, 13 (2022) 713, DOI: 10.1007/s12678-022-00754-2 Figure 1