Abstract:TiO2 is widely considered as one of the promising materials to fulfill photoelectrochemical water splitting requirements for its low cost, nontoxicity, photostablity, and strong photo oxidation ability. Several synthesis approaches have been reported to fabricate TiO2 nanostructures, including template assisted hydrothermal, anodization, and sol-gel. Among them, anodization method is capable of producing highly ordered, well aligned TiO2 nanotubes (NTs) with controlled diameters and tube length. The unidirectional tubular structure provides the charge transport channels from electrolyte/photoanode interface to conductive substrate. The intrinsic band gap of TiO2 (3.2eV for anatase and 3.0eV for rutile), however, limits its optical absorption only within UV region. The rapid recombination rate of photo-excited electrons and holes also severely hinders its practical application.1 Many approaches have been developed to promote the photo response of TiO2 in visible light region. For example, by hetero coupling, the holes and electrons can be photo excited from the narrow-gap semiconductor and separated effectively, which significantly promotes the visible light response. To form hetero coupling, cobalt oxide, a typical P-type semiconductor with band gap of ~2.1eV is chosen. Recent report shows cobalt oxide coupled with TiO2 exhibit could enhance the photo oxidation activity under visible light illumination.2 CoOx/TiO2 nanoparticles also show great photocatalytic activity on water splitting. Here we report the formation of CoOx/TiO2 NTs hetero coupling by atomic layer deposition (ALD). ALD is ultrathin film deposition technique to have sub-nanometer control of film thickness. As a promising method to passivate and modify photoanode,3 ALD could form chemical bonds on substrate and operate at a relatively low temperature. We will show that by uniformly depositing a layer of cobalt oxide film onto the TiO2 nanotubes, CoOx/TiO2 NTs system exhibits one fold improvement on photocurrent response under visible light illumination compared with pristine TiO2 NTs, and about two times the efficiency of CoOx/TiO2 synthesized via wet-chemistry method. The structure was detailed studied and optimized, and mechanism will also be discussed. References: 1. S. Kurian, H. Seo and H. Jeon, The Journal of Physical Chemistry C, 2013, 117, 16811-16819. 2. T. Q. Ngo, A. Posadas, H. Seo, S. Hoang, M. D. McDaniel, D. Utess, D. H. Triyoso, C. B. Mullins, A. A. Demkov and J. G. Ekerdt, Journal of Applied Physics, 2013, 114, 084901-084908. 3. S. C. Riha, B. M. Klahr, E. C. Tyo, S. Seifert, S. Vajda, M. J. Pellin, T. W. Hamann and A. B. F. Martinson, Acs Nano, 2013, 7, 2396-2405.

Anodic TiO2 Nanotubes for Hydrophobic Coatings and Photo-electrochemical Water Splitting Application

Fabrication of Well-Aligned Tio2 Nanotube Arrays with Outstanding Light-Induced Hydrophilicity Performance

Mn/Fe co-doped TiO 2 nanotube arrays for photoelectrochemical water splitting in neutral medium

Application of Titanate Nanotubes for Water Treatment

Self-organized TiO2 Nanotube Arrays with Uniform Platinum Nanoparticles for Highly Efficient Water Splitting

Fully Depleted Ti-Nb-Ta-Zr-O Nanotubes: Interfacial Charge Dynamics and Solar Hydrogen Production

A Study on Cu Decorated Anodic TiO2 Nanotubes for Non-Enzymatic Glucose Sensing and Photoelectrochemical Water Splitting Application

Effect of TiO2 Nanotube Arrays Morphology/Structure on Photocatalytic Hydrogen Production

(Invited) Enhanced Photoelectrocatalytic Activity for Splitting Water Based on Heterostructured TiO<sub>2</sub> Nanotube Arrays

Fabrication of Self-Organized Tio2 Nanotubes by Anodization and Its Photocatalytic Properties

Fabrication of TiO2 Nanotube by Electrochemical Anodization: Toward Photocatalytic Application

Photoelectrochemical performance of TiO2 nanotube arrays modified with Ni2P Co-catalyst

High Photoelectrochemical Water Splitting Performance on Nitrogen Doped Double-Wall TiO2 Nanotube Array Electrodes

Na-deposited TiO 2 nanotubes for photo electrochemical water splitting with enhanced activity – A novel approach

Nb Doped Tio2 Nanotubes for Enhanced Photoelectrochemical Water-Splitting

Invited) Doped Titania Oxide Nanotubes for Photoelectochemical Water Splitting

Enhanced Photoelectrochemical Property of TiO 2 Nanotube Array Photoanode Deposited with Al,Cr-Codoped SrTiO 3 Nanocubes

Synthesis and Study of SrTiO3/TiO2 Hybrid Perovskite Nanotubes by Electrochemical Anodization

Unraveling the Effect of the Water Content in Nh4f/Nh4pf6 Based Electrolyte on the Photocathodic Protection Performance of Tio2 Nanotube Arrays

Characteristics and Electronic Properties of Self-Organized Tio2 Nanotube Arrays Fabricated on Ti Foil by Square Wave Pulse Anodizing Ti in an Hf + H2so4 Solution

Enhanced Visible-Light Photoelectrochemical Performance of Titana Nanotubes Modified by Atomic Layer Deposited Cobalt Oxide