Abstract:2,6-diamino-3,5-dinitropyrazine-1-oxide (LLM-105) is a typical high-energy and low-sensitivity energetic material (EM), which has excellent detonation performance and thermal stability. Based on quasi-harmonic approximation, the dispersion corrected density functional theory was used to study the intermolecular interactions and thermodynamic properties of energetic LLM-105 crystal. By introducing the zero-point energy and temperature effect corrections, PBE-D3 dispersion correction scheme could significantly improve the calculation accuracy of structural parameters at experimental temperature (294 K). The temperature dependent lattice parameters and thermal expansion coefficients exhibit strong anisotropy, especially the thermal expansivity in b -axis orientation (intermolecular layers) is much higher than that in the ac plane (intramolecular layers). Through Hirshfeld surface and fingerprint analysis, it was found that the intermolecular interactions of LLM-105 are mainly O···H hydrogen bonding interactions. The change of intermolecular interactions would result in the rotation of nitro group, which could contribute to form new hydrogen-bonding interaction pattern. Mulliken population analysis shows that the bond order of C−NO 2 bond is more sensitive to the change of temperature, which may be the trigger bond for the high-temperature decomposition reaction of LLM-105. The fundamental thermodynamic properties of EMs can not only provide key parameters for mesoscopic or macroscopic thermodynamic simulations, but also gain theoretical insights into the temperature effects of EMs. Specific heat capacity reflects the amount of heat to be supplied to heat the matter and it is important to the risk assessment of EMs during storage or when exposed to external thermal stimuli. Herein, the basic thermodynamic parameters, such as heat capacity, entropy, bulk modulus and elastic constants under different conditions are predicted. Among them, the calculated heat capacity and entropy describe the nonlinear behaviors within the temperature range of 0−500 K, and the calculated isobaric heat capacity C p ( T ) is in good agreement with the available experimental measurements. The elasticity of materials describes the macroscopic response of crystals to external forces, and the bulk modulus B 0 of molecular crystals can be determined through the equation of state, which is an important parameter for evaluating material stiffness. The bulk modulus under adiabatic conditions is in reasonable agreement with experimental values, and the evolution of bulk modulus with temperature reflects the softening behaviors of LLM-105 at temperature. Furthermore, the complete set of second-order elastic constants (SOECs) of LLM-105 is calculated and 13 independent SOECs ( C 11 , C 12 , C 13 , C 15 , C 22 , C 23 , C 25 , C 33 , C 35 , C 44 , C 46 , C 55 , C 66 ) are predicted. With the increasing temperature, all elastic constants gradually decrease due to the weaken of intermolecular interactions of LLM-105. Overall, these results would fundamentally provide a deep understanding of temperature effects and serve as a reference for the experimental measurement of the thermodynamic parameters of EMs.

Pressure effects on the thermal decomposition of the LLM-105 crystal

The Pressure-Induced Phase Transition of the Solid -Hmx

Ab Initioand Molecular Dynamics Studies of Solid Β-Hmx: Effects of Hydrostatic Pressure and High Temperature

The first principle studies of the structural and vibrational properties of solid β-HMX under compression

Publisher’s Note: Thermal Decomposition of the Solid Phase of Nitromethane:Ab InitioMolecular Dynamics Simulations [phys. Rev. Lett.105, 188302 (2010)]

Melting Curves And Entropy Of Fusion Of Body-Centered Cubic Tungsten Under Pressure

Pressure-Modulated Dissolution Behavior of LLM-105 Crystals in High-Temperature Water

Temperature and pressure effects on the decomposition mechanisms of 2,6-diamino-3,5-dinitropyrazine-1-oxide crystal: ab initio molecular dynamics study

Structural, mechanical properties, and vibrational spectra of LLM-105 under high pressures from a first-principles study

Theoretical study on intermolecular interactions and thermodynamic properties of LLM-105

Impacts of Functional Group Substitution and Pressure on the Thermal Conductivity of ZIF-8

Computational analysis of mesoscale thermomechanical ignition behavior of impacted LLM-105 based explosives

Pressure induced weakness of electrostatic interaction and solid decomposition in Cs-I compounds

The pressure-induced phase transition of the solid β–HMX

Cluster Evolution in Thermal Decomposition of CL-20/TNT Co-Crystal in Compressed State:A ReaxFF Reactive Molecular Dynamics Simulation Study

Temperature and pressure effect on the HMX/Graphene mixture system thermal decomposition via ReaxFF molecular dynamic simulation

Thermal decomposition mechanisms of energetic CL-20-based co-crystals: quantum molecular dynamics simulations

First-principles study of the structural transformation, electronic structure, and optical properties of crystalline 2,6-diamino-3,5-dinitropyrazine-1-oxide under high pressure

Thermal Equations of State and Melting of Lithium Deuteride under High Pressure

Investigating the decomposition mechanism of CL-20/MTNI cocrystal explosive under high temperature and high pressure using ReaxFF/lg molecular dynamics simulations

Pressure Effect on Crystallization Kinetics in Zr46.8Ti8.2Cu7.5Ni10Be27.5 Bulk Glass