Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Ab Initioand Molecular Dynamics Studies of Solid Β-Hmx: Effects of Hydrostatic Pressure and High Temperature

First-Principles Study of High-Pressure Behavior of Solid β-HMX

The first principle studies of the structural and vibrational properties of solid β-HMX under compression

Properties and Phase Transitions of the Solid Β-HMX: Different Force Fields

Phase Transitions and Mechanical Properties of Octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine in Different Crystal Phases by Molecular Dynamics Simulation

The Pressure-Induced Phase Transition of the Solid -Hmx

Anisotropic Responses and Initial Decomposition of Condensed-Phase Β-Hmx under Shock Loadings Via Molecular Dynamics Simulations in Conjunction with Multiscale Shock Technique.

Theoretical Investigation of the High Pressure Structure, Lattice Dynamics, Phase Transition, and Thermal Equation of State of Titanium Metal

The pressure-induced phase transition of the solid β–HMX

Compression and Phase Diagram of Lithium Hydrides at Elevated Pressures and Temperatures by First-Principles Calculation

Ab Initio Studies On Phase Transition, Thermoelastic, Superconducting And Thermodynamic Properties Of The Compressed Cubic Phase Of Alh3

Ab Initio Calculation of Lattice Dynamics and Thermodynamic Properties of Beryllium

Initial decomposition mechanism of solid-state HMX for steady shock waves

The high-pressure phase transitions and vibrational properties of zinc-blende XTe (X = Zn, Cd, Hg): Performance of local-density-approximation density functional theory

A first-principles investigation of the equation of states and molecular "weak spots" of $β$-cyclotetramethylene tetranitramine (HMX)

The Anisotropic Structure Deformation of β-Octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine under High Pressure: A Vibration Spectra Calculation and Resolving Based on AIMD Simulation

Ab initio studies of 1,3,5,7-tetranitro-1,3,5,7-tetrazocine/1,3-dimethyl-2-imidazolidinone cocrystal under high pressure using dispersion corrected density functional theory

Theoretical investigation of vibrational and electronic properties of HMX crystal under uniaxial compression

First-principle Studies on the Mechanical, Thermodynamic and Electronic Properties of Β″-Mg3gd and Β′-Mg7gd Alloys under Pressure

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

The Structural, Mechanical and Thermodynamic Properties of Ti-B Compounds under the Influence of Temperature and Pressure: First-principles Study