Abstract:Molten lead (Pb) and its alloys (PbBi and PbLi) are of immense interest for various nuclear engineering applications, including but not limited to advanced Lead-cooled Fast Reactors (LFRs), tritium Breeding Blankets (BBs) of fusion power plants and spallation targets for Accelerator-Driven Systems (ADS). Owing to their attractive thermophysical properties, these advanced fluids assert their candidacy to address the critical requirements of neutron multiplication, neutron moderation, high temperature coolants and tritium breeders, enabling the operation of next generation nuclear systems at high temperatures with better efficiencies. However, for numerous reasons such as a compromise of structural integrity at the heat transfer interface, presence of an inert cover gas during charging of molten metal in the loop, and the fusion fuel cycle itself may lead to molten metal-gas two-phase flows with high density ratios. At present, no effective diagnostics exist to detect such operational and accidental occurrences in high temperature molten metal systems resulting in a severe lack of relevant experimental studies. To address these limitations and to advance the current understanding toward two-phase regimes in high temperature Pb-based melts, the present work focuses on the design and assembly aspects of an electrical conductivity-based two-phase detection sensor array, utilizing high purity α-Al 2 O 4 coatings with AlPO 4 binder as electrical insulation layers. This paper discusses the design considerations, thermal analysis, systematic selection of structural/functional components along with preliminary results from the probe performance tests in very high temperature (600°C) static molten Pb column for real time detection of argon gas bubbles rising within the melt. Quantitative estimations of time-averaged void fraction, average bubble impaction frequency and average bubble residence time are presented from the preliminary experimental investigations.

Thermal conductivity of lead and bismuth-lead eutectic melts up to 1300 K

Lead-Bismuth Eutectic: Atomic and Micro-Scale Melt Evolution

Metal-non-metal transition in lead-bismuth eutectic

Thermal conductivity of solid solutions of Bi2(Te1-xSex )3 (x = 0-0.07)

Density and thermal expansion of indium–lead melts

Enthalpy and heat capacity of lead in a condensed state

Experimental determination of phonon thermal conductivity and Lorenz ratio of single-crystal bismuth telluride

Contact Angle Measurement of Molten Lead-Lithium on Silicon Carbide Surfaces

Influence of Second Phase Particles on Thermal Conductivity of Bi Alloys

MEASUREMENTS OF FINE STRUCTURES IN THE LEAD-BISMUTH EUTECTIC ALLOY MELTS BY DIFFERENTIAL SCANNING CALORIMETRY

Peculiarities of the Eutectic Mg–Li Alloy Thermal Expansion, Heat Capacity and Thermal Conductivity Behavior in the Temperature Range of 80 K to 293 K

Thermal Conductivity of Three-Dimensional Nanostructured Bi85sb15 Solid Solution

Velocity Profile Measurement of Lead-Lithium Flows by High-Temperature Ultrasonic Doppler Velocimetry

Thermal Conductivity: V, High‐Temperature Method and Results for Alumina, Magnesia, and Beryllia from 1000° to 1800°C

Enthalpy and heat capacity of liquid Na15Pb4 and Na50Pb50 alloys

Impact of Bi content on the accuracy of oxygen concentration measurements in liquid Pb-Bi alloys

Design, fabrication and validation of an electrical conductivity principle based two-phase detection sensor array for molten lead (Pb) based heavy metal coolants up to 600^∘C

High temperature ultrasonic transducers for imaging and measurements in a liquid Pb/Bi eutectic alloy

Thermodynamic Investigations of Liquid Cerium–bismuth Alloys

Devices for Thermal Conductivity Measurements of Electroplated Bi for X-ray TES Absorbers

Studies of the Thermal Conductivity and Thermal Resistance of Solder Layers with Lead-Free Pastes by the Photodeflection Method