Abstract:This paper reports the development of a sapphire (�� - Al 2O 3) single crystal optical fiber thermometer using two wavelength bands. A thin film of precious metal or ceramic deposited onto one end of the sapphire fiber forms a mini-radiation cavity. The other end of the sapphire fiber is coupled to a low-loss silica fiber. Radiation from the small cavity is transmitted along the silica fiber into a photodetection system which consists of a lens, beam splitter, two interference filters (820 nm and 940 nm center wavelength, 30 nm bandwidth) and two silicon photocells. The temperature measurement is based on the detection of radiation from the small cavity. The sapphire fiber (0.25 - 1.0 mm diameter, 100 - 450 mm length) was grown by the laser heated pedestal growth (LHPG) methods. Transmission loss in the sapphire fiber was experimentally measured. Theoretical analysis shows the apparent emittance of the small cavity with a length to diameter (L/D) ratio greater than eight is a constant value near to one, so the small cavity can be considered as a small black-body cavity. Using the developed sapphire fiber temperature sensor, we have built a sapphire fiber thermometer based on a 8098 single-chip microcomputer system. It was calibrated at some known stable temperature point and uses the fundamental radiation law to extrapolate to other temperatures. By taking the ratio of the optical power at two wavelengths, errors due to changes in the system, such as emissivity and transmission losses, can be canceled out. The thermometer has an operating temperature range of 800 to 1900 degrees Celsius, and an accuracy of 0.2% at 1000 degrees Celsius. There are a number of applications of the thermometer both in science and industry.

Thermal lensing in cryogenic sapphire substrates

Reduction of thermal fluctuations in a cryogenic laser interferometric gravitational wave detector

Influence of non-uniformity in sapphire substrates for a gravitational wave telescope

Characterization of birefringence inhomogeneity of KAGRA sapphire mirrors from transmitted wavefront error measurements

Enabling cryogenic gravitational wave detectors: growth of sapphire crystals with record low absorption in the near infrared

Measurement of the mechanical loss of a cooled reflective coating for gravitational wave detection

Characterisation of birefringence inhomogeneity of KAGRA sapphire mirrors from transmitted wavefront error measurements

Thermal lensing measurements of Ti: Sapphire crystal pumped at 80 MHz picosecond pulses by Shack-Hartmann wavefront sensor

Anti-reflection coating with mullite and Duroid for large-diameter cryogenic sapphire and alumina optics

Simulation of Bulk-Absorption Thermal Lensing in Transmissive Optics of Gravitational Waves Detectors

A study of enhancing the power of a CW Ti:sapphire laser by cryogenic cooling

Evaluation of heat extraction through sapphire fibers for the GW observatory KAGRA

Feedback Control of Thermal Lensing in A High Optical Power Cavity

Cryogenic sapphire optical reference cavity with crystalline coatings at 1 × 10-16 fractional frequency instability

Cryogenic sapphire optical reference cavity with crystalline coatings at $\mathrm{ 1 \times 10^{-16}}$ fractional instability

Measurement of Sapphire Wafer Thermo-Optic Coefficient Using High-Temperature Optical Fiber Sensors

Design and experimental study for lens working at both room and low temperature

Optical properties of sapphire fiber under high temperature

Development Of A Sapphire Fiber Thermometer Using Two Wavelength Bands

Current status of the CLIO project

Photothermal and thermo-refractive effects in high reflectivity mirrors at room and cryogenic temperature