Abstract:Bearing vibration characteristic analysis based on dynamic analytical model is of importance for identifying faults of bearing in mechanical systems. However, on one hand, the relationship between the raceway-ball contact pairs in bearing dynamic models are often considered as a simplified cascade; on the other hand, the evolving law of bearing fault characteristics of the early fault (wear) and severe fault (pitting) has not been fully revealed, which confines the development of bearing fault feature extraction and severity assessment methods. This paper, therefore, constructs a dynamic analytical model considering time-varying contact pairs and parameterized defects of deep groove ball bearings (DGBB) to illustrate the dynamic vibration characteristics of DGBB under different health conditions. The degrees of freedom of balls and flexible cage, multi-parameter defect excitation, mixed-elastohydrodynamic lubrication (mix-EHL), and relative slippage are all considered in the proposed model. Positions of multiple rigid bodies and contact points are dynamically expressed by coordinate systems, from which system physical parameters and geometrical relationship can be obtained. The bearing early and severe fault excitations are described by multi-parameters. The early fault which is embodied as surface roughness yields the indirect displacement excitation and the severe fault yields the direct displacement excitation. The surface roughness and indirect displacement excitation affect the mix-EHL, the radial force and friction force of contact pairs, thereby affecting the vibration response of DGBB. The evolving mechanism analysis of bearing fault characteristics are then revealed based on the established dynamic model, indicating the coupling and nonlinear relationship between the characteristic frequency amplitude and the fault severity of DGBB.

Dynamic modeling, analysis, and experimental study of ball screw pairs with nut spalling faults in electromechanical actuators

Dynamic modeling and vibration response analysis of high speed motorized spindle

Dynamic Behavior Analysis of a Rotor-Bearing-Squeeze Film Damper Coupling System with Bearing Outer Race Localized Defect

Dynamic analysis and modeling of ball screw feed system with a localized defect on the support bearing

Model for dynamic characteristics produced by inner race local defect in ball bearing system and its simulation

A time-dependent dynamic model for ball passage vibration analysis of recirculation ball screw mechanism

Methodology For Ball Screw Component Health Assessment And Failure Analysis

A Physics-based Model-data-driven Method for Spindle Health Diagnosis, Part II: Dynamic Simulation and Validation

Dynamic Modeling of a Ball-Screw Drive and Identification of Its Installation Parameters

Dynamic modeling and vibration analysis for the gear-rotor-bearing system with localized failures

Dynamic Modelling of Gearbox with Multiple Localized Defects and Its Coupled Vibration Analysis

Dynamic Modeling and Simulation of Inter-Shaft Bearings with Localized Defects Excited by Time-Varying Displacement

Dynamic Modeling of Gear System Based on 3D Finite Element Model and Its Application in Spalling Fault Analysis

A Physics-based Model-data-driven Method for Spindle Health Diagnosis, Part I: Modeling of Geometric Faults

Degradation reliability modeling for ball screws subject to fatigue elastic failure mode

Dynamic modeling considering time-varying contact pairs and parameterized defects of deep groove ball bearings for its vibration characteristic analysis

Fault Feature Extraction Method of Ball Screw Based on Singular Value Decomposition, CEEMDAN and 1.5DTES

Dynamic modeling and force-vibration mapping mechanism construction of rolling bearings considering cage flexibility and local faults

An investigation of dynamic characteristics in rotor-bearing system with combined bearing and coupling defects

Vibration characteristics analysis of flexible helical gear system with multi-tooth spalling fault: Simulation and experimental study

A comprehensive misalignment-rub-impact nonlinear dynamic spindle model considering contact angle and fit clearance under EHL