Abstract:Piezoelectric devices based on high-temperature stable single crystals are of increasing interest due to a wide range of potential applications, such as actuators and resonant gravimetric sensors. The latter require highly accurate resonant-frequency measurements at temperatures as high as 1000 °C, and this can only be achieved with narrow resonance peaks and correspondingly low acoustic loss at these temperatures. Relevant atomistic defects in langasite (La 3 Ga 5 SiO 14 , LGS) and catangasite (Ca 3 TaGa 3 Si 2 O 14 , CTGS) are reviewed with respect to their impact on electrical conductivity and acoustic loss. The focus on these crystals also enables a comparison of electroacoustic properties of partially disordered (LGS) and ordered (CTGS) crystals and the formulation of approaches for reducing acoustic loss and enhancing device performance. Starting with defect chemistry models for LGS and CTGS, electrical conductivities as a function of temperature and oxygen partial pressure are considered. One result of this analysis is that contributions of oxygen ions to the total conductivity are determined to be relatively small in the studied crystals. Temperature-dependent acoustic loss of LGS and CTGS crystals is also studied. Two independent techniques, contact resonant piezoelectric spectroscopy, and a contactless tone-burst excitation technique, are applied. Contributions to the measured acoustic loss are determined by fitting loss-related functions for point defects and conductivity-related relaxations. The extracted fit parameters, in particular the activation energies of the processes, are discussed and compared with that of the electrical conductivity. The losses are caused by a superposition of several mechanisms including conductivity-related relaxations, point-defect relaxations and intrinsic phonon-phonon loss. The long-term stability of the crystals is also evaluated at 1000 °C with respect to fundamental materials properties including electrical conductivity and resonant frequency. After one year of thermal treatment, the resonance frequency of CTGS resonators from different crystal sources is found to decrease by no more than 0.4 %. Thus, the applicability of CTGS as a piezoelectric resonator that operates for long periods at extreme temperatures, such as a resonant nanobalance, is demonstrated. Application examples to be presented include resonant nanobalances for in-situ monitoring of non-stoichiometry and phase transformations in thin films during growth at high temperatures. In this context, the key application properties of the sensors at high temperatures, such as mass sensitivity and resolution, are discussed. As an application example, the attached figure shows the oxygen non-stoichiometry x of thin praseodymium-cerium oxide films (Pr 0.1 Ce 0.9 O 2-x ) at 700 °C as a function of oxygen partial pressure determined by LGS and CTGS nanobalances, which agrees very well with literature data (chemical capacitance: D. Chen et al., Chem. Mater. 2014, 26, 22, 6622–6627). Figure 1

Temperature-dependent properties of wurtzite and rock salt Sc x Al 1-x N for applications in BAW resonators

Electro-Acoustic Properties of Scandium-Doped Aluminum Nitride (ScxAl1-xN) Material and its Application to Phononic Crystal-Coupled SAW Devices

AlScN‐on‐SiC Thin Film Micromachined Resonant Transducers Operating in High‐Temperature Environment up to 600 °C

Effects of High-Temperature Thermal Annealing on the Crystal Structure and Phase Separation in Sputtered ScAlN Thin Films

Phonon heat conduction in Al1-xScxN thin films

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Al1−xScxN Thin Films at High Temperatures: Sc-Dependent Instability and Anomalous Thermal Expansion

Large Piezoelectric and Elastic Properties in B and Sc Codoped Wurtzite AlN

X-Band Bulk Acoustic Wave Resonators with High Figure of Merit Based on Al0.8Sc0.2N

Alscn Thin Film Based Surface Acoustic Wave Devices with Enhanced Microfluidic Performance

Aluminum Scandium Nitride as a Functional Material at 1000°C

High Performance AlScN Thin Film Based Surface Acoustic Wave Devices with Large Electromechanical Coupling Coefficient

Preparation, Characterization, and Application of AlN/ScAlN Composite Thin Films

A phenomenological thermodynamic energy density function for ferroelectric wurtzite Al1−xScxN single crystals

Unprecedented Enhancement of Piezoelectricity in Wurtzite Nitride Semiconductors via Thermal Annealing

Epitaxial Growth of Sc0.09Al0.91N and Sc0.18Al0.82N Thin Films on Sapphire Substrates by Magnetron Sputtering for Surface Acoustic Waves Applications

AlScN-on-SiC microelectromechanical Lamb wave resonators operating at high temperature up to 800 °C

Temperature Performance Study of SAW Sensors Based on AlN and AlScN

High-Temperature Piezoelectric Resonators: Electroacoustic Properties and Applications of Langasite-Type Crystals

High Quality Co-Sputtering AlScN Thin Films for Piezoelectric Lamb-Wave Resonators

High-Performance SAW Resonators Based on Single-crystalline a-Plane AlN Thin Films on Sapphire Substrates