Abstract:The trend related to reach the high operating temperature condition (HOT, temperature, T > 190 K) achieved by thermoelectric (TE) coolers has been observed in infrared (IR) technology recently. That is directly related to the attempts to reduce the IR detector size, weight, and power dissipation (SWaP) conditions. The room temperature avalanche photodiodes technology is well developed in short IR range (SWIR) while devices operating in mid-wavelength (MWIR) and long-wavelength (LWIR) require cooling to suppress dark current due to the low energy bandgap. The paper presents research on the potential application of the HgCdTe (100) oriented and HgCdTe (111)B heterostructures grown by metal-organic chemical vapor deposition (MOCVD) on GaAs substrates for the design of avalanche photodiodes (APDs) operating in the IR range up to 8 µm and under 2-stage TE cooling (T = 230 K). While HgCdTe band structure with molar composition xCd < 0.5 provides a very favorable hole-to-electron ionization coefficient ratio under avalanche conditions, resulting in increased gain without generating excess noise, the low level of background doping concentration and a low number of defects in the active layer is also required. HgCdTe (100) oriented layers exhibit better crystalline quality than HgCdTe (111)B grown on GaAs substrates, low dislocation density, and reduction of residual defects which contribute to a background doping within the range ~1014 cm-3. The fitting to the experimentally measured dark currents (at T = 230 K) of the N+-ν-p-P+ photodiodes commonly used as an APDs structure allowed to determine the material parameters. Experimentally extracted the mid-bandgap trap concentrations at the level of 2.5 × 1014 cm-3 and 1 × 1015 cm-3 for HgCdTe (100) and HgCdTe (111)B photodiode are reported respectively. HgCdTe (100) is better to provide high resistance, and consequently sufficient strength and uniform electric field distribution, as well as to avoid the tunneling current contribution at higher bias, which is a key issue in the proper operation of avalanche photodiodes. It was presented that HgCdTe (100) based N+-ν-p-P+ gain, M > 100 could be reached for reverse voltage > 5 V and excess noise factor F(M) assumes: 2.25 (active layer, xCd = 0.22, k = 0.04, M = 10) for λcut-off = 8 μm and T = 230 K. In addition the 4-TE cooled, 8 μm APDs performance was compared to the state-of-the-art for SWIR and MWIR APDs based mainly on III-V and HgCdTe materials (T = 77-300 K).

Controlling of Avalanche Dark Carriers in Realizing Hot Single Photon Detector

High-performance HgCdTe avalanche photodetector enabled with suppression of band-to-band tunneling effect in mid-wavelength infrared

Tuning Performance Parameters of Ge-on-Si Avalanche Photodetector, Part II: Large Bias Operation

Design of a Bandgap-Engineered Barrier-Blocking HOT HgCdTe Long-Wavelength Infrared Avalanche Photodiode

Performance Optimization of Hg1-xCdxTe Photovoltaic Detectors Under Strong Illumination Considering Temperature and Wavelength Dependencies

Temperature-Dependent Characteristics of HgCdTe Mid-Wave Infrared E-Avalanche Photodiode

Study on dark current suppression of HgCdTe avalanche photodiodes for low flux photon detection

Investigation of HgCdTe avalanche photodiodes for HOT condition

Enhanced Performance of HgCdTe Midwavelength Infrared Electron Avalanche Photodetectors with Guard Ring Designs

Improved performance of HgCdTe infrared detector focal plane arrays by modulating light field based on photonic crystal structure

In 0.52 Al 0.48 As Based Single Photon Avalanche Diodes With Stepped E-Field in Multiplication Layers and High Efficiency Beyond 60%

Mechanism of dark current dependence on reverse voltage in mid-wavelength infrared HgCdTe mesa PIN avalanche diode

High-operating-temperature mid-infrared photodetectors via quantum dot gradient homojunction

Dark Current in Long-Wave Cascade-Transport Infrared Up-Converters

Low Dark Current HgCdTe Long Wavelength Infrared Photodiodes with Bandgap Gradient Multi-Layer Heterojunction

Study of HgCdTe (100) and HgCdTe (111)B Heterostructures Grown by MOCVD and Their Potential Application to APDs Operating in the IR Range up to 8 µm

Gain and Excess Noise in HgCdTe e-Avalanche Photodiodes at Various Temperatures and Wavelengths

Low Excess Noise, High Quantum Efficiency Avalanche Photodiodes for Beyond 2 μm Wavelength Detection

Multi-Physics Field Based Simulation on the Response and Saturation Properties of Hg1-xCdxTe Based Photovoltaic Detectors With Composition Gradients

Enhanced Performance of HgCdTe Long-Wavelength Infrared Photodetectors with Nbn Design

Black Arsenic Phosphorus Mid-Wave Infrared Barrier Detector with High Detectivity at Room Temperature