Abstract:The trend related to reach the high operating temperature condition (HOT, temperature, T > 190 K) achieved by thermoelectric (TE) coolers has been observed in infrared (IR) technology recently. That is directly related to the attempts to reduce the IR detector size, weight, and power dissipation (SWaP) conditions. The room temperature avalanche photodiodes technology is well developed in short IR range (SWIR) while devices operating in mid-wavelength (MWIR) and long-wavelength (LWIR) require cooling to suppress dark current due to the low energy bandgap. The paper presents research on the potential application of the HgCdTe (100) oriented and HgCdTe (111)B heterostructures grown by metal-organic chemical vapor deposition (MOCVD) on GaAs substrates for the design of avalanche photodiodes (APDs) operating in the IR range up to 8 µm and under 2-stage TE cooling (T = 230 K). While HgCdTe band structure with molar composition xCd < 0.5 provides a very favorable hole-to-electron ionization coefficient ratio under avalanche conditions, resulting in increased gain without generating excess noise, the low level of background doping concentration and a low number of defects in the active layer is also required. HgCdTe (100) oriented layers exhibit better crystalline quality than HgCdTe (111)B grown on GaAs substrates, low dislocation density, and reduction of residual defects which contribute to a background doping within the range ~1014 cm-3. The fitting to the experimentally measured dark currents (at T = 230 K) of the N+-ν-p-P+ photodiodes commonly used as an APDs structure allowed to determine the material parameters. Experimentally extracted the mid-bandgap trap concentrations at the level of 2.5 × 1014 cm-3 and 1 × 1015 cm-3 for HgCdTe (100) and HgCdTe (111)B photodiode are reported respectively. HgCdTe (100) is better to provide high resistance, and consequently sufficient strength and uniform electric field distribution, as well as to avoid the tunneling current contribution at higher bias, which is a key issue in the proper operation of avalanche photodiodes. It was presented that HgCdTe (100) based N+-ν-p-P+ gain, M > 100 could be reached for reverse voltage > 5 V and excess noise factor F(M) assumes: 2.25 (active layer, xCd = 0.22, k = 0.04, M = 10) for λcut-off = 8 μm and T = 230 K. In addition the 4-TE cooled, 8 μm APDs performance was compared to the state-of-the-art for SWIR and MWIR APDs based mainly on III-V and HgCdTe materials (T = 77-300 K).

Design of a Bandgap-Engineered Barrier-Blocking HOT HgCdTe Long-Wavelength Infrared Avalanche Photodiode

Temperature-Dependent Characteristics of HgCdTe Mid-Wave Infrared E-Avalanche Photodiode

Enhanced Performance of HgCdTe Long-Wavelength Infrared Photodetectors with Nbn Design

High-performance HgCdTe avalanche photodetector enabled with suppression of band-to-band tunneling effect in mid-wavelength infrared

Enhanced Performance of HgCdTe Midwavelength Infrared Electron Avalanche Photodetectors with Guard Ring Designs

Study of HgCdTe (100) and HgCdTe (111)B Heterostructures Grown by MOCVD and Their Potential Application to APDs Operating in the IR Range up to 8 µm

Controlling of Avalanche Dark Carriers in Realizing Hot Single Photon Detector

Bandwidth Characteristics of Mid-Wavelength Infrared PIN HgCdTe Avalanche Photodiodes

Investigation of HgCdTe avalanche photodiodes for HOT condition

A bandgap-engineered HgCdTe PBπn long-wavelength infrared detector

Gain and Excess Noise in HgCdTe e-Avalanche Photodiodes at Various Temperatures and Wavelengths

Design of uncooled mid-wave infrared detectors based on lead selenide barrier structure

Dark-Current-Blocking Mechanism in BIB Far-Infrared Detectors by Interfacial Barriers

Study on dark current suppression of HgCdTe avalanche photodiodes for low flux photon detection

Enhanced Low-Noise Gain from InAs Avalanche Photodiodes with Reduced Dark Current and Background Doping

Mechanism of dark current dependence on reverse voltage in mid-wavelength infrared HgCdTe mesa PIN avalanche diode

Low Dark Current HgCdTe Long Wavelength Infrared Photodiodes with Bandgap Gradient Multi-Layer Heterojunction

Low-temperature-dependent Property in an Avalanche Photodiode Based on GaN/AlN Periodically-Stacked Structure

Black Arsenic Phosphorus Mid-Wave Infrared Barrier Detector with High Detectivity at Room Temperature

Low excess noise HgCdTe e-SWIR avalanche photodiode operating at high gain and temperature

A Pmt-Like High Gain Avalanche Photodiode Based on Gan/Aln Periodically Stacked Structure