Abstract:In modern gas turbines, efforts are being made to improve efficiency even further. This is achieved primarily by increasing the generated pressure ratio in the compressor and by increasing the turbine inlet temperature. This leads to enormous loads on the components in the hot gas region in the turbine. As a result, non-destructive testing and structural health monitoring (SHM) processes are becoming increasingly important to gas turbine manufacturers. Initial cracks in the turbine blades must be identified before catastrophic events occur. A proven method is the linear ultrasound method. By monitoring the amplitude and phase fluctuations of the input signal, structural integrity of the components can be detected. However, closed cracks or small cracks cannot be easily detected due to a low impedance mismatch with the surrounding materials. By contrast, nonlinear ultrasound methods have shown that damages can be identified at an early stage by monitoring new signal components such as sub- and higher harmonics of the fundamental frequency in the frequency spectrum. These are generated by distortion of the elastic waveform due to damage/nonlinearity of the material. In this paper, new global nonlinear parameters were derived that result from the dual excitation of two different ultrasound frequencies. These nonlinear features were used to assess the presence of cracks as well as their qualitative sizes. The proposed approach was tested on several samples and turbine blades with artificial and real defects. The results were compared to samples without failure. Numerical simulations were conducted to investigate nonlinear elastic interaction of the stress waves with the damage regions. The results show a clear trend of nonlinear parameters changing as a function of the crack size, demonstrating the capability of the proposed approach to detect in-service cracks.

Blade tip characteristics of turbine disks with cracks

Research on the Influence of Crack Parameters on the Vibration Characteristics of Gas Turbine Compressor Blades

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

Research on Vibration Characteristics of Last Stage Blade Based on Blade Tip-Timing Technology

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

Dynamic characteristic analysis of rotating blade with breathing crack

An improved analytical dynamic model for rotating blade crack: With application to crack detection indicator analysis

Dynamic Characteristic Analysis of Rotating Blade With Transverse Crack—Part II: A Comparison Study of Different Crack Models

Nonlinear vibration characteristics and damage detection method of blade with breathing fatigue crack

Numerical Study on the Dynamic Behavior of a Francis Turbine Runner Model with a Crack

Nonlinear dynamic behavior of rotating blade with breathing crack

Detection of blade substrate crack parameters of hard-coated blisk based on mistuning identification technology

Crack Diagnosis of Wind Turbine Blades Based on EMD Method

Dynamic modeling and verification of rotating compressor blade with crack based on beam element

Method for evaluation of surface crack size of wind turbine main shaft by using ultrasonic diffracted waves

Dynamic Characteristic Analysis of Rotating Blade With Transverse Crack—Part I: Modeling, Modification, and Validation

Dynamics Behavior of Multi-Disk Flexible Rotor System with Transverse Crack

A Nonlinear Ultrasonic Modulation Method for Crack Detection in Turbine Blades

Non-Contact Wind Turbine Blade Crack Detection Using Laser Doppler Vibrometers

Experimental and Numerical Investigation on the Influence of a Large Crack on the Modal Behaviour of a Kaplan Turbine Blade