Abstract:Purpose:Silicon photomultiplier (SiPM) has recently emerged as a promising photodetector for biomedical imaging applications. Due to its high multiplication gain (comparable to PMT), fast timing, low cost and compactness, it is considered a good candidate for photon counting CT. Dark noise is a limiting factor which impacts both energy resolution and detection dynamic range. Our goal is to develop a comprehensive model for noise sources for SiPM sensors.Methods:The physical parameters used in this work were based upon a test SPAD fabricated in 130nm CMOS process. The SPAD uses an n+/p‐well junction, which is isolated from the p‐substrate by a deep n‐well junction. Inter‐avalanche time measurement was used to record the time interval between two adjacent avalanche pulses. After collecting 1×106 counts, the histogram was obtained and multiple exponential fitting process was used to extract the lifetime associated with the traps within the bandgap.Results:At room temperature, the breakdown voltage of the SPAD is ∼11.4V and shows a temperature coefficient of 7.7mV/°C. The dark noise of SPAD increases with both the excess biasing voltage and temperature. The primary dark counts from the model were validated against the measurement results. A maximum relative error of 8.7% is observed at 20 °C with an excess voltage of 0.5V. The probabilities of after‐pulsing are found to be dependent of both temperature and excess voltage. With 0.5V excess voltage, the after‐pulsing probability is 63.5% at ‐ 30 °C and drops to ∼6.6% at 40 °C.Conclusion:A comprehensive noise model for SPAD sensor was proposed. The model takes into account of static, dynamic and statistical behavior of SPADs. We believe that this is the first SPAD circuit simulation model that includes the band‐to‐band tunneling dark noise contribution and temporal dependence of the after‐pulsing probability.

Analysis of noise and its characteristics in avalanche photodiode

Noise Characteristic Of Algan Based Solar-Blind Uv Avalanche Photodiodes

Tuning Performance Parameters of Ge-on-Si Avalanche Photodetector, Part II: Large Bias Operation

Analysis of APD Characteristics Based on Equivalent Circuit Model

Temperature Dependent Low-Frequency Noise Characteristics of AlGaN Avalanche Photodiodes with Ultra-Shallow Bevel Edge Termination

A Noise Model for Multilayer Graded-Bandgap Avalanche Photodiodes

Theoretical Study of Enhancing the Performance of InP/InGaAs Avalanche Photodiodes with p‐Type‐Doped InP Interposed Layer

Characteristics of Thin InAlAs Digital Alloy Avalanche Photodiodes.

Avalanche Mechanism Analysis of 4H-Sic N-I-p and P-I-n Avalanche Photodiodes Working in Geiger Mode

Repeated radiation damage and thermal annealing of avalanche photodiodes

Separate absorption, charge, and multiplication staircase avalanche photodiodes

Radiation damage of InGaAs avalanche photodiode under gamma ray irradiation

Low Noise Equivalent Power InAs Avalanche Photodiodes for Infrared Few-Photon Detection

Noise Characterization of Geiger-Mode 4H-Sic Avalanche Photodiodes for Ultraviolet Single-Photon Detection

Noise Analysis of Photonic Digital-to-analog Converters.

Avalanche Photo-Detection for High Data Rate Applications

High-speed InAlAs digital alloy avalanche photodiode

Focus on the Avalanche Breakdown Characteristic of Si- and InP-Based APDs Irradiated by Fast Neutrons

Spatial Description Theory of Narrow-Band Single-Carrier Avalanche Photodetectors.

Enhancing Linearity of Light Response in Avalanche Photodiodes by Suppressing Electrode Size Effect

TH‐CD‐207B‐07: Noise Modeling of Single Photon Avalanche Diode (SPAD) for Photon Counting CT Applications