Abstract:Recent trends in the construction industry have sought to use cold-formed (CF) carbon steel, CF aluminium and CF stainless-steel as flexural members and in some instances as primary load-carrying members. Flexural members when subjected to concentrated loads undergo various failure modes, a major failure mode being web crippling. The large width-to-thickness ratios of these thin-walled beams makes them vulnerable to local buckling failure. Although there are four loading conditions to consider, this paper focuses on Interior-One-Flange (IOF) loading condition. Currently, individual design equations are available for determining the web crippling capacity of CF carbon steel, CF aluminium and CF stainless-steel under IOF loading. However, to-date there has been no attempt to produce a unified web crippling design equation. An all-encompassing numerical study focussed on the key web crippling parameters, both cross-sectional dimensions and mechanical properties and a unified grade, fy = 220 MPa, was achieved across the three structural materials to allow for a unified design equation. A total of 378 Finite Element (FE) models were obtained. It was found that AS/NZS 4600, AISI S100 and Eurocode 3 provided good agreement, but with a higher coefficient of variation (COV) values than recommended. Additionally, AS/NZS 1664.1 was found to be unsafe. CF carbon steel parametric study results validated existing equations, which were accurate and able to predict the web crippling capacity under IOF loading. However, unified web crippling design equation was modified which can improve the accuracy when predicting the web crippling capacity of CF aluminium and CF stainless-steel lipped channel sections (LCBs) under IOF loading conditions. The unified equation was supplemented by web crippling coefficients specific to each of the structural materials.

Nonlinear web crippling analysis and design of cold-formed high strength steel channel sections having different stiffened flanges

Design Approach of Stiffeners in Extended End Plate Connections and Finite Element Analysis

Web crippling design of channel beams: Carbon steel, stainless steel and aluminium

Approach to Stiffen Column Flange and Web in Bolt End-Plate Connections

Stiffened Approach of Column Flange and Web in Bolt End-plate Connections

Web crippling of stainless steel built-up I-sections under End-Two-Flange loading: Tests, simulations and design

Design of Cold-Formed Steel Built-Up Closed Sections with Intermediate Stiffeners

Web bearing design of cold-formed austenitic stainless steel un-lipped channels under localised interior loading

Web Crippling Behaviour of Cold-Formed Carbon Steel, Stainless Steel, and Aluminium Lipped Channel Sections with Web Openings

Web crippling investigation of perforated aluminium lipped channels under interior-one-flange loading condition

Structural Design for Roll-Formed Aluminium Alloy Perforated Channels Subjected to Interior-Two-Flange Web Crippling: Experimental Tests, Numerical Simulation, and Neural Network

LOCAL BUCKLING OF THIN-WALLED HIGH STRENGTH STEEL COLUMNS WITH WEB STIFFENERS

Compressive Behavior and Design Calculations of CFST Slender Columns with Latticed Annular Steel Part

Stub Column Tests of Thin-Walled Complex Section with Intermediate Stiffeners

Compression Tests Of Cold-Formed Steel C- And Z-Sections With Different Stiffeners

Web Crippling Strength of Cold‐Formed Steel Beams

Behavior and Design of Slender Concrete-Filled Wide Rectangular Steel Tubular Columns under Axial Compression

Cold-formed steel lipped channel columns at elevated temperatures

Cold-Formed Steel Built-Up Closed Sections With Intermediate Stiffeners

Column tests of cold-formed steel non-symmetric lipped angle sections

Design for local buckling behaviour of welded high strength steel I-sections under bending