Abstract:The steel, whose nominal yielding strength f(y) is greater than or equal to 460 MPa, is generally referred to as high strength steel (HSS). Through the comparison with conventional strength steel (CSS) members, HSS members are more vulnerable to local buckling since the component plates are usually designed to be more slender in order to exploit higher material strength. The different mechanical properties between HSS and CSS, including yielding strength, ductility and so on, may lead to different local buckling behavior of steel members. However, little guidance is applicable in existing standards for the stability design of HSS members. In this paper, elaborate finite element (FE) models of HSS welded I-section beams under the loading conditions of uniform moment (four-point loading) and moment gradient (three-point loading) were developed by means of the general-purpose FE software package and validated against the available test results. Continuous lateral supports were ideally applied to restrict the occurrence of coupling with overall lateral-torsional buckling. Comprehensive parametric analyses on key parameters containing the plate width-to-thickness ratio and the steel material properties were further conducted, reflecting the influence of these parameters on the mechanical performance of local stability. Through this work, the variation rules on rotation capacity and postbuckling resistance of HSS welded I-section beams with plate width-to-thickness ratio and steel nominal yielding strength were clarified. Taking into account the interaction of local buckling modes between flanges and webs, new cross-section classification of HSS welded I-section beams was proposed based on the FE analysis results. After the introduction of the concept of interactive local slenderness, the design methods of postbuckling ultimate moment resistance for HSS welded I-section beams subjected to uniform moment and moment gradient were also proposed, which were assessed by comparing the design results with the ones obtained from the corresponding design approaches in Eurocode 3, ANSI/AISC 360-16 and GB 50017-2017. And the reliability of the new proposals was also confirmed by further statistical analysis.

Web Crippling Strength of Cold‐Formed Steel Beams

Finite element analysis on shear capacity of the corrugated web H-shaped steel beam

Web crippling design of channel beams: Carbon steel, stainless steel and aluminium

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Nonlinear web crippling analysis and design of cold-formed high strength steel channel sections having different stiffened flanges

Design of Cold-Formed Steel Built-Up Closed Sections with Intermediate Stiffeners

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

LOCAL BUCKLING OF THIN-WALLED HIGH STRENGTH STEEL COLUMNS WITH WEB STIFFENERS

Flexural behavior of cold-formed steel I-beams strengthened in the web with different materials

Compression Tests Of Cold-Formed Steel C- And Z-Sections With Different Stiffeners

Local Buckling Tests on Cold-Formed Steel Beams

Cold-Formed Steel Built-Up Closed Sections With Intermediate Stiffeners

Web crippling tests of cold-formed stainless steel tubular sections at elevated temperatures

Postbuckling Resistance of High Strength Steel Welded I-section Beams Based on Interactive Slenderness

Web Crippling Behaviour of Cold-Formed Carbon Steel, Stainless Steel, and Aluminium Lipped Channel Sections with Web Openings

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Web crippling of stainless steel built-up I-sections under End-Two-Flange loading: Tests, simulations and design

Global Buckling Design of Multi-Celled CFST Walls with Four Simply-Supported Edges

Experimental and Theoretical Research on Mechanical Behavior of Innovative Composite Beams

Web crippling investigation of perforated aluminium lipped channels under interior-one-flange loading condition

Experiment Study on Flexural Performance of Web-Encased Steel-Concrete Composite Beams