Abstract:In the study, the creep characteristics and meso-mechanism of calcareous sand under different stresses are explored through triaxial creep tests. The influence of particle size on calcareous sand creep is also considered. Furthermore, the particularity of calcareous sand creep is revealed by comparing with the creep behavior of silica sand. The results show that during creep, the calcareous sand is more stable than silica sand due to the interlocking of irregular particles. When creep deviatoric stress is small, the creep of calcareous sand is manifested as nonlinear attenuation creep (primary creep), and the creep deformation is smooth without creep failure. With the increase of creep deviatoric stress, the creep deformation is concentrated, resulting in a strain concentration zone similar to the shear band, and the associated creep rate first decreases and then suddenly increases, finally, creep failure occurs. With increasing particle size of calcareous sand, the particle crushing increases, which induces a higher creep deformation, however, the overall creep failure is not generated. During the graded creep of calcareous sand, an obvious creep structural effect is observed, which is temporary and results in a significantly reduction of creep rate. Only after the previous creep structure effect is destroyed by the continuously creep process, the creep response can restore to its original behavior. The meso-behavior is represented by particle morphology, i.e., the fractal dimension and aspect ratio. It is found that both confining pressure and particle size can influence the evolution of particle morphology during creep. With the increase of confining pressure, the fractal dimension of calcareous sand decreases which means that particle grinding is always existent, while the aspect ratio of small-sized calcareous sand after creep decreases first and then stabilizes (slightly increases), suggesting that the overall particle breakage is the main cause of deformation. However, the aspect ratio of large-sized calcareous sand continually decreases, indicating that the main contribution for its deformation is angular cracking. The meso scopic behavior of silica sand is basically unaffected by creep, and its creep deformation is mainly caused by particle rearrangement.

DEM simulations of soil creep due to particle crushing

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

DEM Simulation of Creep in One-Dimensional Compression of Crushable Sand

Three-dimensional Discrete Element Simulation of the Triaxial Cyclic Loading of Sandstone Based on a Nonlinear Parallel-Bonded Stress Corrosion Model

The kinematics and micro mechanism of creep in sand based on DEM simulations

DEM simulation on soil creep and associated evolution of pore characteristics

DEM Modeling of Particle Breakage in Silica Sands under One-Dimensional Compression

Simulation Study of Breakage in Coral Sand Particles under Dynamic Confined Compression

Particle breakage evolution of coral sand using triaxial compression tests

Nonlinear creep properties and time-to-failure prediction of sandstone under saturated and dry conditions

Micro-mechanism of brittle creep in saturated sandstone and its mechanical behavior after creep damage

The creep characteristics and related evolution of particle morphology for calcareous sand

Cyclic-loading effects in sand: a micromechanical study considering particle breakage

Combined study of creep and ageing under deviatoric loading in granular materials

Creep, Ageing and Microstructural Change in Dense Granular Materials

Multi-stepped creep constitutive model based on asymptotic damage evolution behavior of sandstone

Damage creep model of viscoelastic rock based on fractional derivative and experimental verification

DEM Simulations of the Creep Behavior of Cemented Methane Hydrate-Bearing Sand

Creep behavior and long-term strength characteristics of pre-peak damaged sandstone under conventional triaxial compression

Cumulative deformations and particle breakage in calcareous sand subjected to drained high-cyclic loading: Experimental investigation