Abstract:In order to meet the growing industrial demand of high quality and high efficiency machining, long cutters with larger axial depth of cut are extensively implemented in peripheral milling of deep pockets, grooves, and thin-wall parts. However, due to their high flexibilities, chatter easily occurs during the machining process. It has been demonstrated that milling cutters with variable pitch and/or variable helix angles can mitigate the chatter, which are gaining increasingly important applications. Although this kind of cutters have been studied in some detail in previous research, few studies have focused on the interaction dynamics complicated by actual cutter runout in long tool-part contact zone. This paper systematically studies the dynamics and stability of variable-pitch/helix milling system with long end cutters. The cutters are divided into a series of axial disks, and each axial disk includes several cutting elements which are equal to the number of teeth. Variations of pitch and helix angles, cutter run-outs including radial offset and axial tilt, and mode shapes with the cross terms in the orthogonal direction, are assigned to these cutting elements. The system, involving multiple regenerative delays as well as the axially varying dynamics, is formulated as a matrix form of time-periodic delay differential equation with multi-modal dynamic parameters. An updated cross-axis and cross-point modal testing method is then proposed to obtain the dynamic parameters, which can effectively avoid multiple hits when impacting the cutter with hammer. The stability lobes are predicted in state space by developing an improved semi-discretization method, by which the pitch variations and actual runout effects on stability are investigated. It is shown that the stability lobes differ significantly when the combined effects of cross-axis and cross-point FRFs and actual cutter runout are considered. A series of cutting experiments is conducted to demonstrate the proposed model and method. Results show that these lobes well agree with the experimental results.

On the effect of radial engagement on the milling stability of modes perpendicular to the feed direction

Experimental and simulation study on chatter stability region of integral impeller with non-uniform allowance.

Parameter Optimization of Time-Varying Stiffness Method for Chatter Suppression Based on Magnetorheological Fluid-Controlled Boring Bar

Stability analysis for milling system with variable pitch cutters under variable speed

Chatter stability analysis of variable speed milling with helix angled cutters

Analysis of the Influence of Mill Helix Angle on Chatter Stability

Robust Chatter Stability Prediction of the Milling Process considering Uncertain Machining Positions

Optimum Selection of Variable Pitch for Chatter Suppression in Face Milling Operations

Effects of Helix Angle and Multi-Mode on the Milling Stability Prediction Using Full-Discretization Method

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Research on milling stability of thin-walled parts based on improved multi-frequency solution

Chatter suppression analysis for variable pitch cutter in milling

Chatter Stability Prediction of Ball-End Milling Considering Multi-Mode Regenerations

Prediction of Chatter Considering the Effect of Axial Cutting Depth on Cutting Force Coefficients in End Milling

Modeling of variable-pitch/helix milling system considering axially varying dynamics with cutter runout offset and tilt effects

Research on the influence of robot structural mode on regenerative chatter in milling and analysis of stability boundary improvement domain

Stability Analysis of Milling Based on the Barycentric Rational Interpolation Differential Quadrature Method

Effect of the Cutter Path and the Workpiece Clamping Position on the Stability of the Robotic Milling System

Investigation on chatter stability of thin-walled parts milling considering the effects of fixture support force and tool position

An efficient and precise stability analysis method for milling process

Modelling of the stability of variable helix end mills