Abstract:For the battery- or USB-powered portable smart devices, which supply their computing cores with a wide-range sub-volt rail, the energy-efficient high and wide voltage-conversion-ratio (VCR) converters are crucially important. In addition, low form factor and decent transient responses are also favorable for such applications. Prior state-of-the-art designs either use single-stage hybrid designs using multi-level or Dickson converters [1 – 3], or adopt two-stage cascaded architectures with a highly efficient unregulated front (or rear) stage [4], as shown in Fig. 18.6.1 (left). The multi-level designs, which conduct the full inductor current through all the on-state switches, are suited to low-to-medium power levels with limited current density. The Dickson converters take advantage of a high conversion ratio, however, at the cost of reduced output voltage range. The two-stage designs which show decent output range and efficiency, however, can suffer from heavy load efficiency degradation considering that the efficiency of both stages degrade with increasing load and the overall efficiency which is the product of the efficiencies of the two stages is severely degraded. Inspired by the inductive-sigma converter [5] which shunts a highly efficient unregulated LLC with a regulated Buck, this work proposes a reconfigurable capacitive-sigma converter. By input-series and output-shunting a highly efficient unregulated switched-capacitor (SC) converter with a reconfigurable Dickson hybrid Buck stage, the power stage input current is reused and output currents are combined. Therefore, the overall efficiency is greatly improved in a wide continuous VCR range and with an enhanced loading capacity. Besides, as will be demonstrated, the proposed design shows inherently decent load transient and regulation performances.

An NMOS-LDO Regulated Switched-Capacitor DC–DC Converter With Fast-Response Adaptive-Phase Digital Control

Capacitor-free, fast transient response CMOS low-dropout regulator with multiple-loop control

Inverter-Based Fast Transient Response Capacitor-Less LDO

A Capacitor-less Digital LDO Using Ripple-Frequency-Adaptive Time-domain Digital Pre-distortion Technique

A Fast-Transient Output-Capacitor-Less Low-Dropout Regulator With Direct-Coupled Slew Rate Enhancement

An Impedance Adapting Compensation Scheme for High Current NMOS LDO Design

A Four-Phase Digital Buck Converter With MDLL-Based Adaptive Switching Frequency Compensation

A 5V Input 98.4% Peak Efficiency Reconfigurable Capacitive-Sigma Converter with Greater Than 90% Peak Efficiency for the Entire 0.4~1.2V Output Range.

An Ultrafast Adaptively Biased Capacitorless LDO With Dynamic Charging Control.

Buck Converter with Load Adaptive Losses and 256x sub-mW Load Transient Response Time of 0.8 ms using Synchronous Control

A Fast-Transient Capacitor-Less LDO with Dual Paths Active-Frequency Compensation Scheme

A Reconfigurable Step-Down Switched-Capacitor Power Converter Using Optimized Partial Series-Parallel (OPSP) Topology

A Low-Power Ultra-Fast Capacitor-Less LDO with Advanced Dynamic Push-Pull Techniques

A 2.5 MHz, 6 A Ripple-Based Adaptive On-Time Controlled Buck Converter with Pseudo Triangular Ramp Compensation

High-Efficiency Synchronous Dual-Output Switched-Capacitor Dc-Dc Converter With Digital State Machine Control

A Fast Transient Response Capacitor-Less LDO with Transient Enhancement Technology

A DC-DC Converter with Switched-Capacitor Delay Deadtime Controller and Enhanced Unbalanced-Input Pair Zero-Current Detector to Boost Power Efficiency

A New Improved Ultra-Fast-Response Low-Transient-Voltage Buck Converter With Transient-Acceleration Loops and V-Cubic Techniques

A 1.8μa, 202 Ns Fast Transient Response Output Capacitor-Less LDO with Dual Power Transistors

A Capacitor-less LDO with Fast-transient Error Amplifier and Push-pull Differentiator

An Input-Output Regulated Adaptive Ramp for Fast Load Transition of PWM Buck Convertor.