MODELING AND IDENTIFICATION OF THE COOLING AND SOLIDIFICATION PROCESS CONTINUOUSLY CAST SLAB BILLETS
,V. Panferov,S. Panferov,
DOI: https://doi.org/10.14529/met240108
2024-01-01
Bulletin of the South Ural State University Series ‘Metallurgy’
Abstract:Introduction. The problem of parametric identification of a mathematical model of the process of cooling and solidification of continuously cast slabs in the secondary cooling zone (SZZ) of continuous casting machines (CCMs) is considered. The relevance of the work is determined, first of all, by the fact that the quality of the product obtained in this way significantly depends on the operating mode of the air defense system. The technological process is quite complex, not fully studied and, as a result, still poorly managed. Purpose of the study. Develop a procedure for parametric identification of a model of the metal cooling and solidification process based on data available for direct measurement. Materials and methods. An analysis and synthesis of literature data on the problem was carried out. An acceptable structure of the mathematical model was determined, a criterion for the proximity of the object and the model was selected, and the problem of its parametric identification was posed and solved. Results. An acceptable formula has been determined to describe the real temperature field in the workpiece after the metal leaves the mold. A numerical study has established that the identification problem under consideration is solved stably and with almost any predetermined accuracy, and an increase in the number of surface temperature measurement points significantly increases the noise immunity of the solution. When describing external heat transfer in radiative-convective form, the identification problem was solved using a program that implements the coordinate descent method; the resulting one-dimensional minimization problems were solved using a subroutine using the golden section method. To numerically integrate the model equations, an implicit finite-difference scheme was used, which was solved by the sweep method. In the case where the external heat transfer of the workpiece is described only in convective form, a program using the golden section method has been developed and tested. The curves of changes over time of process variables calculated using the adjusted model are presented. Conclusion. A mathematical model tuned to the “real process” was used to identify the features of the metal cooling process in the production plant of the continuous casting plant of PJSC MMK; in particular, based on the results of the study, the coolant costs along the production line were adjusted.