Abstract:Introduction. The problem of parametric identification of a mathematical model of the process of cooling and solidification of continuously cast slabs in the secondary cooling zone (SZZ) of continuous casting machines (CCMs) is considered. The relevance of the work is determined, first of all, by the fact that the quality of the product obtained in this way significantly depends on the operating mode of the air defense system. The technological process is quite complex, not fully studied and, as a result, still poorly managed. Purpose of the study. Develop a procedure for parametric identification of a model of the metal cooling and solidification process based on data available for direct measurement. Materials and methods. An analysis and synthesis of literature data on the problem was carried out. An acceptable structure of the mathematical model was determined, a criterion for the proximity of the object and the model was selected, and the problem of its parametric identification was posed and solved. Results. An acceptable formula has been determined to describe the real temperature field in the workpiece after the metal leaves the mold. A numerical study has established that the identification problem under consideration is solved stably and with almost any predetermined accuracy, and an increase in the number of surface temperature measurement points significantly increases the noise immunity of the solution. When describing external heat transfer in radiative-convective form, the identification problem was solved using a program that implements the coordinate descent method; the resulting one-dimensional minimization problems were solved using a subroutine using the golden section method. To numerically integrate the model equations, an implicit finite-difference scheme was used, which was solved by the sweep method. In the case where the external heat transfer of the workpiece is described only in convective form, a program using the golden section method has been developed and tested. The curves of changes over time of process variables calculated using the adjusted model are presented. Conclusion. A mathematical model tuned to the “real process” was used to identify the features of the metal cooling process in the production plant of the continuous casting plant of PJSC MMK; in particular, based on the results of the study, the coolant costs along the production line were adjusted.

MODELING AND IDENTIFICATION OF THE COOLING AND SOLIDIFICATION PROCESS CONTINUOUSLY CAST SLAB BILLETS

An Experimental and Numerical Study on the Modelling of Fluid Flow, Heat Transfer and Solidification in a Copper Continuous Strip Casting Process

Identification of Convection Heat Transfer Coefficient of Secondary Cooling Zone of CCM based on Least Squares Method and Stochastic Approximation Method

Computational modeling and control system of continuous casting process

Mathematical modelling of fluid flow, heat transfer and solidification in a strip continuous casting process

Solidification Modeling of Continuous Casting Process

Heat-transfer and solidification model of continuous slab casting: CON1D

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Simulation and application of dynamic heat transfer model for improvement of continuous casting process

Simulation of the Technological Process of Manufacturing Continuous Metal Products on a Casting and Forging Module with a New Modification

Investigation of Solidification, Heat Transfer and Fluid Flow in Continuous Casting of Steel Using an Advanced Modeling Approach

Uncertainty Quantification in Modeling Mold Heat Transfer in Steel Continuous Slab Casting with CON1D

Mathematical modelling of fluid flow, heat transfer and solidification phenomena in continuous casting of steel

Optimization and Control of Secondary Cooling Parameters of Continuous Casting

Temperature Distribution and Dynamic Control of Secondary Cooling in Slab Continuous Casting

Applying of Real-time Heat Transfer and Solidification Model on the Dynamic Control System of Billet Continuous Casting

Online Modelling of Heat Transfer, Solidification and Microstructure in Continuous Casting of Steel

Simulation of the Heat-Transfer Conditions in a CCM Mold

Real‐Time Heat Transfer Model Based on Distributed Thermophysical Property Calculation for the Continuous Casting Process

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting