Abstract:The chipping and grinding processes are the basis for understanding rock cutting during TBM excavation in hard rock conditions. The chips are produced when tensile fractures created by adjacent cutters propagate parallel to the tunnel face and coalesce whereas grinding occurs when fractures do not fully propagate through the rock and only fines are generated. Chipping is the normal and efficient boring process using machines equipped with disc cutters. Consequently, almost all of the models proposed for predicting the TBM penetration have been developed by the assumption that chipping is the dominant mode. It is obvious that these models are unable to predict correctly TBM performance when grinding is dominated in the rock cutting process. In this study, the relationships between engineering geological properties of the rock units (Cretaceous limestones) and operating and performance parameters of a refurbished EPB-TBM, employed for completion of SEL6 (the Southern Extension of Line 6, Tehran Metro) tunnel, were evaluated and analyzed. In this project due to limitations in the load capacity of the employed cutters and insufficient initial penetration in rock, the excavation was mostly carried out on grinding-dominated mode. So, the suitable data for establishing a special database and consequent analyses were provided. The established database composed of actual operating and performance parameters of the machine (i.e., cutterhead penetration and RPM and cutter load) and also engineering geological properties (i.e., UCS, alpha angle, GSI, and RQD) of limestone strata. Finally, by statistical analyses performed on collected and screened data (41 data sets), some simple, site-specific, empirical equations were developed to predict the TBM performance on grinding mode. In addition, according to the multivariate regression method, a significant relationship between the cutterhead penetration (PRev), the cutter load (Fn), intact rock strength (UCS), and geological strength index (GSI) was established, statistically. The obtained results demonstrate that this engineering geological-based model could provide a new applicable equation for accurately predicting TBM performance for similar geological conditions where grinding is dominant.

Experimental and numerical investigation of the TBM disc cutter wear using a new tunnel boring machine laboratory simulator

Evaluating the wear of cutting tools using a tunnel boring machine laboratory simulator

Experimental Study on Partial Wear of TBM Disc Cutter

Numerical investigation of temperature distribution on a tunnel boring machine disc cutter affected by geomechanically and excavation parameters

The energy method to predict disc cutter wear extent for hard rock TBMs

Development of a Real-Time Monitoring and Calculation Method for TBM Disc-Cutter's Cutting Force in Complex Ground

Tracking of disc cutter wear in TBM tunneling: a case study of Kerman water conveyance tunnel

Performance Evaluation of TBM Using an Improved Load Prediction Model

Evaluation of TBM Cutter Wear in Naghadeh Water Conveyance Tunnel and Developing a New Prediction Model

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Enhanced Wear Prediction of Tunnel Boring Machine Disc Cutters for Accurate Remaining Useful Life Estimation Using a Hybrid Model

Analytical Research on the Wear Mechanism of TBM Disc Cutters Based on an Energy Approach

Evaluating the influence of engineering geological parameters on TBM performance during grinding process in limestone strata

Evaluation of TBM Cutter Wear in Granite and Developing a Cutter Life Prediction Model for Face Cutters Based on Field Data: A Case Study

The performance of TBM disc cutter in soft strata: A numerical simulation using the three-dimensional RBD-DEM coupled method

TBM performance analysis in very strong and massive rocks; case study: Kerman water conveyance tunnel project, Iran

A field parameters-based method for real-time wear estimation of disc cutter on TBM cutterhead

Development of a Prediction Model for the Wear Evolution of Disc Cutters on Rock TBM Cutterhead

Force and wear prediction model of disc cutter under compression shear failure mode based on dense core–cavity expansion theory (U-713)

Numerical and Experimental Research on the Rock-Breaking Process of Tunnel Boring Machine Normal Disc Cutters

EPB-TBM cutterhead torque and thrust modelling in rock tunnels through an analytical method and TSFS model